2 12" Kenwood KFC-XW12R D3 ohm subs

[HotRodHam]

so me n a friend hooked up his subs 2 12" Kenwood KFC-XW12Rs to his 2 Kenwood KAC-PS1D we are trying to wire them at 6 ohms for now (the subs are Dual 3 ohm) but the amp has a weird thing [picture below]

this is the best site for the amp i could find for power rating --> http://130.com.ua/en...nwood-kac-ps1d/

i was wondering though if u look at the sub u can see that u have to put fuses in if im wiring it to 6 ohms not 1.5 where would i set the fuses? the options are (parallel, B-Amp, or series) where would i put the fuses and would i just connect the + and - of opposite coils to raise the ohm load like any other dual coil sub?

and how would i wire em if i was going to wire it down to 1.5 ohms? (fuse placement and wiring)

im being extra cautious cuz these subs n amps arent cheap to replace.

thanks ahead of time for the help

[HotRodHam]

nvm i found a owners manual online so i got it all

close this thread please