BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Top baffle cut out Wrapped in suede Installed. Screwed on from the inside of the box Amps bolted to front of box Back of battery rack attached Battery rack installed. It screws into the box under the 4500 Deadener on front floor Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 1/2" threaded rod through back of the box attached to trunk seal Steel angle bracket to support top baffle cutout Wiring Battery fuses and interior leds 4500 fuses Underbody LED kit switch by drivers right knee Interior LED module under driver seat Remote gain knob Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Foil and masking tape for kick pods 6.5 and tweeter rings for kick pods Fiberglassing base of the kick pods Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Mounting speaker rings to pod base Wrapped pods and fiberglassed 2 layers of resin first 3 layers of resin and mat Sanded and trimmed 3 layers of milkshake Sanded and test fit Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Wrapped in suede Interior leds Through front windshield Subs with rear dome light turned on. 6k led bulbs Some outside pics Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Wiring mounted to side of box Making side beauty panels Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Ensolite foam inside the doors Mass loaded vinyl The car has very little road noise Expanding foam on backside of trunk seal Deadener in trunk to help vibration and road noise Link to comment Share on other sites More sharing options...
BoogerMan Posted May 10, 2016 Author Report Share Posted May 10, 2016 Did a 149.7 at 38hz for my first meter. The cross braces in my roof were broken and there was zero deadening on the roof at this point. I also wasn't clipping on the gain remote knob so after deadening my roof and pushing the subs a little harder I should be able to break 150. I'm happy with the results for my daily ground pounder. Pulled the headliner down Panel bonded the braces back to the roof Gluing some wood to the roof near the back window with PL 8X. This spot flexes really bad so the wood should help 2 layers of deadener on the roof. I was going to do wood here too but that would make the sunroof unusable so I went with mat instead. Should be okay Great stuff around the wood That's it for now. I cut my thumb on a table saw Saturday night so finishing up the roof came to a halt. Luckily I'm okay and didn't need surgery or stitches but my left hand is pretty sore. I have to keep it bandaged the next few days so I still need to get the headliner put back up. I'll post some videos tomorrow. Feel free to ask any questions! Thanks for looking Link to comment Share on other sites More sharing options...
solar0987 Posted May 10, 2016 Report Share Posted May 10, 2016 All the pics are upside down haha. Looks epic thought. Link to comment Share on other sites More sharing options...
killallblue Posted May 10, 2016 Report Share Posted May 10, 2016 so so so much upside down Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.