Kicker ZX550.2

[r00k]

I figure i know what the deal is but... before i think i know it all i wanted to ask.

My subs are DVC 4ohm wired to 2 ohm. When i bridge this amp i can hardly get any "volume" before the

amp goes into protect. Running it straight up "non-bridged" it runs ok...

Now what i'm thinking is my power drops so the amp cuts off. Being i don't have the

big 3 or a h/o alt. Anyone have a ideas on why i go into protect when i'm bridged?

Gains: 1/4

Bass Boost: 1/2

I kept trying to go down with them till i just wired it straight and came and asked.

[Guest]

turn bassboost off. and that amp can only run 4 ohms bridged not 2 ohms bridged. end thread

keep each coil on each channel. 400rms total there you go.

[r00k]

Thanks!