boys from oklahoma Posted June 16, 2010 Report Share Posted June 16, 2010 10.09277 before anything 8.76407 after port (1.32870 ft³) 8.44407 after subs (0.32 ft³) 8.366524 after supports (0.077546 ft³) 2.091631 per sub ft³ leaving it tuned @ 32~33 hz correct? it was 8x8x10 and some one said that wasnt enough for how many cubes that are in the box this is a quick drawing i just did so i could figure the port and shizz but the box is 17.75H x42W x28D and the top of the port is 14*8 and the overall length is 20 inches if i am correct.... i think i got it right but if some one sees an error in my calculations lemme know please and this would be the port cutouts here is wat i got now Subs: 4 Rockford Fosgate Power T1 dual 2ohm Amps: 2x alpine mrd-m1005 <--(for sell or trade) rockford 250.2 Speakers: rockford punch 4way 6x9 in doors rockford power 3 way 6x9 rear in boxes dual alts dual batteries 2/0 wiring 300 amp rf fuses Link to comment Share on other sites More sharing options...
boys from oklahoma Posted June 16, 2010 Author Report Share Posted June 16, 2010 im also open to any other suggestions that dont refer to building a whole new box lol if i can just change the port that would be nice since i would just have to pop off the top because the port it just attached to the top portion Subs: 4 Rockford Fosgate Power T1 dual 2ohm Amps: 2x alpine mrd-m1005 <--(for sell or trade) rockford 250.2 Speakers: rockford punch 4way 6x9 in doors rockford power 3 way 6x9 rear in boxes dual alts dual batteries 2/0 wiring 300 amp rf fuses Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.