CJtech323

Big Update, everything is installed and working! Right now I am just tuning the crossover between the sub and components and also tuning the comps. My trunk is a rats nest right now, but Im in the process of building a new box/ amp rack to fit all this equipment in my limited trunk Here are some pics, I'll upload some more later. I used the stock 16ga speaker wire for the woofers And then I applied to Second Skin. I kept on putting down layers in rattling spot until there was no more resonance, up to three layers at some spots. But now my doors are dead silent Didn't take any pics of the building of my door pods, but they are covered in layers of rustoleom for moisture protection. Here is the drivers side And the passengers side The tweeters are mounted in the stock locations, aimed slightly up and towards the opposite seats (passenger tweet aimed towards driver seat and vise versa). This gives a great image, voices sound centered and coming from the bottom center of the windshield. I do have a little alternator whine problem, but thats just because I need to work out the ground. Overall I am highly pleased with the bostons, I ended up putting the tweeters at -4db because they were to profound at first, but they sound excellent now.

Here is a little update, tweeter pods

Alright here are the pics for the passenger door panel. First I cut a lot of little holes Then I went in and snipped the connectors with tin snips There is a wiring harness right behind a section where I drilled through, had to be carefull Then I put a double layer of electrical tape down

Update, here is what I got done today. Cut into the driver side door: And put two layers of electical tape on the edges: Here it is with the window closed, its about 1/2" of space from the door panel: I also soldered all my wires 4 awg 1/0 awg

Thanks, and will do! Here is the amp and ring terminals

My amp for the boston's came in today, I will post pics up later tonight

On-axis mounting hardware Various tweeter mounting hardware pieces The tweeter Finally, the crossovers

Update, cleared out the trunk: And finished laying down the Second Skin in the trunk: Also, my Boston's came today!

Here is the link to my sub build: http://www.stevemeadedesigns.com/board/ind...c=22571&hl=

I posted up my build log for my sub almost a year ago, so I will post a link to that later. This build will be slow since I am very busy with school right now, but I will work on it as much as I can and keep you updated. Here are the specs: Sub: 1 Pioneer Premier TS-W3001D4 12" Sub amp: Rockford Fosgate T1500-1BD Speakers: Boston Acoustics Pro60se Speaker Amp: Rockford Fosgate P400-2 KnuKonceptz wire Second Skin Damplifier And its all tying into the OEM head unit with a 3sixty.1 I am waiting on the speakers and amp in the mail, onto the pics! The car: Sub and box: Now I wonder what could be in these boxes? 8 ft each of Red and black 1/0 awg, 8 ft each of red and black 4 awg, and 75 ft of 12 awg speaker wire And in box #2, 50 sq ft of Damplifier And here is everything I have received: And onto the install! Beginning to lay down the Damplifier on the trunk lid: All done! I put down 6 sq ft And everything buttoned up, I know it peeks out a little bit, but its not that noticeable so Im not worrying about it And thats it for today, I will post more pics as I move along.

As topic says, I dont have an O-scope but do you really need one to properly get my system dialed in with a 3sixty.2? Or can I just do it by ear?

New Video Card, Power Supply, Case Fan, and Thermal Compound

I had it a couple days ago, it was good, but dissapointing. Not as hot as it is shown to be.

Mmmmmm overclocking...

$475 shipped from www.newegg.com