Jump to content

ditch

Members
  • Posts

    5
  • Joined

  • Last visited

Everything posted by ditch

  1. Sorry about that, didn’t mean to hijack a thread, I don’t post much. My bad. Thank you, I did check the fuses, grounds and opened the low pass up all the way, failed to mention that. Thank you for the info. i really appreciate it!
  2. Hey guys, Im struggling here...I’m pretty sure I have blown my sub RE XXX15 Dual 2 ohm, sealed box built to spec for sub. I knew there was good potential for it so it’s not really a surprise. I initially dialed it in with the DD1 and CC1 running a sundown SCV3000. It’s definitely more than the sub can handle and I was aware of that. So, I zeroed the amp out and went to retune it but my phone (Galaxy S9 and my iPad Pro will not generate a tone under 100Hz (think that’s the frequency, may have been higher). I went to D’Amore and downloaded the tones so they should be fine. I tried the CC1 hooked directly to speaker terminals and directly to the incoming RCAS and it isn’t detecting a signal either way. I have a multi meter but didn’t get to that to test the resistance on the sub or output of amp yet. So, I’m looking for suggestions in a couple of areas... 1. A good sub that will handle 3000 watts (I only have space for one) 2. How to generate a low frequency test tone without a CD player. I have Spotify but, holy crap I don’t even want to think about going through the above steps to get a tone😳 3. Any suggestions on the best way to determine if it’s my amp or sub. The next step in my mind short of pulling the sub out to inspect it (giant pain in my A$$) is unhook the speaker outs on the amp, turn it up and check output voltage. Im open to any suggestions or criticism to help get me pounding again. Thank you very much!
×
×
  • Create New...