Dantyson92

That’s a big 10/4 on the two speaker terminal quick connect on bottom of sub box also I have to drill a hole from one sub to the other for that 2 ohm load correct? Sorry I got.a bit off track lol thank. U for your help buddy I appreciate it so much thanks dan

Yea but I have two dvc 2ohm vd10s so I want my rp1500.1 at 2ohm but really I’d love to see the 1ohm load but I screwed up and got the 2ohm subs … I’d I had 2 dvc 4 ohm subs then I can do the 1ohm load … I didn’t know that when. I bought the 2ohm dvc vd10s like a month ago and now I bought all skar amps and door speakers (mids and highs) all skar …. And another thing is I juat bought a kicker nickel plated positive terminal for the battery and it takeS my 1/0 gauge ofc wire and I got a rp75.4 channel amp for my coaxials in my four doors then I got a distribution block 1/0 gauge input to 2 4 gauge output and a 2 farad stinger capacitor for the rp1500.1 now after all this I’ve got I am. Kinda stumped on how to best wire this all up. Can you give any recommendations? Thank you for your help I really appreciate it . ( this is everything I have to install ) “see pics” thank you again dan IMG_1125.MOV

Yea thank you for the help and yes I have a quick connect to both subs

Yes I just bought the rp75.4 abM going to 6x9 coaxials and 5.25 coaxials and rp 1500.1 going to two vd10s from skar and I’m installing today/tomorrow .. how do you suggest that I set the crossover on the 75.4 for the coaxials? There’s a channel 1,2,3,4 with gain ,hpf 20hz to 5000 hz and lpf is 50hz to 500hz im guessing I don’t touch the lpf and set the hpf to 500hz and above ? And it has xover settings for 1&2 and 3&4 a switch has hpf,full,&lp/bp I guess set it on hpf? What does the full position do? And I have a 1/0 gauge wiring kit ofc from skar also am going to run that from battery to a stinger 2 farad capacitor then to a truconnect distribution block 1/0 to 4 gauge and am gonna put that as close to the 1500.1 amp as possible also for clarity if I have 2 2ohm dvc vd10s and wired them pos to pos and neg to neg (not connecting the two subs) then pos and neg to the quick connect speaker in and out straight to pos and neg on amp this is 2 ohm ??? Correct? When you parrellel them and then voice coil to the quick connect in and out the quick connect to the positive and negative on the amp this is 2 ohm or 1/2 ohm I think it’s 2?!! Ughh sorry man I just don’t know everything and really want to do this right. I appreciate any suggestions or comments thank you 🙏 oh yea if you see the picture of the vd10s they’re down facing (inverted) and this is a sealed sub box, what would u suggest? Keep them inverted or put in flush? dan Help dude lol