n31l_m4nu3l

Yo i got new vids, this was my first vid and it was mad cold so i was shiverin.... also my amp is only on a notch of gain so ima make a new vid and post it

Damn dude, nice box. sounds good

nice dude...

An Directed 1200t

Not bad. just testing my amp

Put all 3 40a fuses in and the thing slams.... beat the hell outa my diamonds i might have to do the big 3 and all that. And im confused about the specs to this amp for some reason its just confusing to me. i had this amp on 2 type rs and wired them to 1 ohm and it never blew any fuses played flawless

i played it for a while today wired the same and only half of it got warm..

this morning when i first hooked it up i banged it pretty hard and it hardly got warm with a the 3 30a fuses. ill do what you said and start off with 1 40 then use 2 ect. but ima tinker with my electrical so it will keep my amp from struggle'n as much.

Yes there dual 4's. so i don't even gota take em outa the box. Sweet!... Thanks for your help guys.

Wow thanks alot for the quick responses. Do you guys think i should wire these mono or stereo? and which impedence load that will work with my stock electrical. im glad my amp diddent fry dude! i got a hell of a deal on my system tho

Ok so how would u suggest me wire these at stereo or mono at 4 ohm?

Hm, thats a good question. i'm not quite sure of the exact specs of this amp cuz there hard to come across. but i do kno it has a switch that says mono or stereo. Theres also a LED light that indicates its doing a 1 ohm load. Also theres a switch on the side that says 1ohm or 2/4 ohms. i looked all over for specs for this amp an i coulden't find them.

It hasen't got hot on me yet cuz i cant turn it up!

Running 4 gauge power and some shitty ground i did with a self tapper and like 8 gauge. should i use 4 gauge on the ground? then see what happens...

I'm went over all wireing and coulden't figure it out i was just gonna get like 40a fuses for the amp. someone also told me about fuses called slow blows that are ment for heat idk if hes just bullshit'n... ne1?

I'm Deffently positive i installed it this morning. and i spent prolly 10 dollars in fuses just to bump today and be safe. if i have the same problem when i put an 200a fuse off the battery would it be safe to use higher amp fuses in my amp?

I own a directed 1200t and it calls for 3 30a fuses. its wired at 1 ohm bridged. And once i turn it up to certin point and it pops the fuses like nuthin'. could this be cuz i dont have any inline fuse off the battery?