esedriver567

yes it is a brand name and its a dual voice coil. i think it is the wiring i will take a look. and as i recalled last night the amp was really hot. also my deck is brand new. would it be because inm running a 18 gguage wire for speaker wires? the wires that are hooked up to the coils are ten guage. but i will go through every and get back.

i have a 15" spl suwoofer 2000w, nitro 1200w amplifier i hooked up my system and it slamed shook the car made heads turn. but just todayi got in the car after school and it is not hitting as hard anymore it sounds like a 10" what can cause this? any suggestions would be great thanks!

im on a very low budget andm im trying to find a sound deadener to but on my trunk to stop the rattling my 15 is causing. i heard peel n seal works like dynamat? if thats true where can i get it? what do you guys reccommend?

hi i wanted to know where you got the air ride system. can i have the link please? thanks

no its not going to protect from what im hearing because usualy when it goes to pretect it shuts off the system

i havent taken my sub out for inspection but the wires connected to the amp i basicly live wire wrapped around the screw and put it could that be it?

12 guage wires on sub 8 guage for power and ground and 18 guage for remote ill take a look agian

hi guys i have a audiobahn AT1006 and a lanzr 4 channel 800 watt amp basicly when i first start my car and everything my sub hits hard as usual then like 3 minutes later it doesnt hit as hard it like fades away and then 20 mins later it kicks hard agian for like 3 seconds then back to weak. lpf is only turn a slight but from low and everything else it low anyideas?

awsome work man your good at designing automobile

its a sony cdx-f700

oh thanks for the defense homie anyways my sub wired like a one ohm i wired it like this http://www.the12volt.com/caraudio/woofer_c...sp?Q=1&I=22 the first opyion i think thats the problem if im wrong plus the speaker is running 18 gauge wires

no i got a wireing diagram heres the link http://www.the12volt.com/caraudio/woofer_c...sp?Q=1&I=22 i did the first option plus the speaker is runnin of 18 gage wires which i think is the problem. i need an opinion but you had an awsome idea about One coil to each bridged channel pair.

i just got an amp its a Lanzer Vibe 430 and i hooked it up to my AudioBahn AW 1006T Flame Q Car subwoofer 900w both coils are hooked up i had a 250w amp before this one and it hit no problem with both coils connected. all of my knobs on this amp are turned to minimum basicly when i put my volume at 35% on my deck it hits for 3 seconds then my sub flexes wierdly and then the protect light turns on. i checked all the cables and there fine i just replace the remote wire with an 18 gage. any suggestions would be awsome! will post pics soon.