PlugItIn

Hey everyone, its been awhile since ive been over to SMD lately. But i figure ill share this here, i think the videos are pretty neat actually. itll be awhile till i can continue, as im flying to Texas Monday for a week or so...

5500

Im not too sure about dirtbikes, but my r6 runs 10w-40 in her. It is a fourstroke. You NEED to mix the gas and oil for that bike, and you NEED to run two stroke oil. The tranny will have a specific oil in it as well though...some bikes use the auto tranny fluid, others use different things. Search google for that.

uh, you need two stroke oil brah. Car oil WILL NOT work

was just 3/4 there

should put a nut and washer on each side of the port all thread too

i like that truck...you cuttin that shit up in your house? lol

making some progress, this is just messing around with box placement and such. outlaw

if you're smelling voice coil with 1.5k to a level 5 you're just clipping it all to hell. No I have 4 1500ds 2 on each. The noise got worse today while it was on loud... the sub was moving oddly too. Might have to pull the sub out, check out the glue joint on the cone to coil...

thanks man...its a dd z2hv. You have one?

When I reckoned my level 5s I didn't put enough glue on the dustcap. Deffinatley audible at low volume. Try putting some glue around the cap

Still no where near done. Need to deaden the entire vehicle, seal the wall off from the rear, and beef up mah electrical some. 151.1 was the best she did today...just like in the video. I actually took a picture on that attempt, lol... Outlaw

Temporary... Meh, not too impressed so far with the score...we shall see...