TommyK

Okay how do you not go deaf from your tweets and regular speakers?? because I have just one 15" in a sealed box with just 400 watts and I have to turn down the treble on my HU and turn up the sub just a tad if I feel like bumpin or but then my sub drowns out my speakers to where its hard to hear the song. So when I have my system adjusted to sound perfect my ears start to hurt before the bass is loud enough for me!!! what should I do if I can do anything about it?

Idk about metal to wood but wood to wood you aught to be good any type of wood glue. The mdf or whatever you using will probably break/rip before the glued joints came loose because it fuses the fibers together as if its one peice as long as your using enough to cover the areas completely

Whoops I typed my post completley wrong somehow lol, but no the box was built me.

The 12" sub was a 12" RE REX in a 1.5 cubic foot box tuned to 34Hz and my new 15" is an RE SRX is in a sealed 2.2 cu foot box hooked up to a Fosgate Punch 300 amp, it says 412 RMS on the birthsheet at 2 ohms

I recently got a new system I had a 12" sub in a ported box tuned to 34 Hz but now I got a 15" sub in a 2.2 ft box and it just hits so low omg and its so much louder even though its sealed

Im trying to make my box look like the first one, so how many common port walls would I type in? And if i cut the peices with the cutouts the calculator gave me wouldnt they not fit together right? If I dont have enough port area what does that mean, my sub is not getting enough air? Im trying to squeeze this box in my small trunk hah. Thanks for the feedback though i didnt think anyone was going to get a sketch that fast let alone 3

I want the sub up if thats what you mean bye the long side and port going on the back , I basically just want to make sure the sizes that is tells me to cut the peices are right and what it looks like.

Yea

Yea

I used torres box tuning calculator and it gives me the cutouts: Top:21'' x 28'' Bottom:21'' x 28'' Sides:21'' x 28'' Front/back:21'' x 28'' Port top/bottom:3.5'' x 14.25'' Port sides:10.5'' x 14.25'' what will my box look like wen built?

Its actually a bag of sour patch kids wrapped in a shirt which makes sense because it falls out when it hits him. Regardless though its still funny!

O I got you now. But thats probably what caused the trace to melt was the short?

BUMP

So if I were to leave just the ground plugged into the amp and then touch the positive onto the brushed metal outside it wouldnt cause that to happen? You got me confused because at first you said maybe a + hit a heatsink then you said you doubt that was what caused it.

I just tested that with my multimeter, neg on neg on amp and pos on brushed metal outside and it has continuity. There is a burn mark on the same surface that I thought was from a cigarette but it bet thats what happened. Do you think if I fix it it will keep the amp cooler? or is that just normal for this amp to get a lil toasty?