[Help - Box Build RE MT 15s]

Couple of pics...

[Help - Box Build RE MT 15s]

Car = S10 ext cab (1998)

Box:

I'm thinking either large ported or bandpass if possible. One problem with bandpass (4th order) in this truck is the bed dimensions...only allows for 16" total box height so the subs would have to be angled...not sure if I wanna do that.

If I go ported (leaning towards this) I plan on using the ext cab area to mount the subz...cut-through inside the box and additional box volume in the bed (yeah the cut-through will need special attention to be air tight). I wanna let the beasts breath! ported in the cab from the top of the box followed by 2 45degree angles into the bed. Something like this...

[Help - Box Build RE MT 15s]

No username in the pic but its what I have immediately available.

[Help - Box Build RE MT 15s]

Will Post an image tomorrow. I'll need to unbox them. I understand the request with my "2 Post" count

As for the Amp. I have heard mixed opinions about it. It's what I have so I'm going to run with it for now.

[Help - Box Build RE MT 15s]

OK, I have 2 15 MTs. All the specs I have are:

Sub:

Dual Progressive Spiders

Flat Wound Coils

Dual 1.4 ohm

Dual Tinsel Leads

Electrical (plan):

350 Amp SP AD244 (adjustable VR)

Big wire throughout (1/0 or greater)

Kenetic 16v/12V batts (3 or 4 will add more if needed)

Amp:

SS XXX4000d ( @ 16+V )

Will double after initial install and testing.

I've tried emailing RE with no response...

PORTED:

I would like to know what kind of airspace these need. Looking to port Looowww like high 20's low 30's. Thinking 6" x 30" for port surface area then port length to the box for the target frequency.

Thanks in advance for any help...

/cheers