pssstgotbags94

Just toss this in here. Even though no one likes my crappy build lol And after the drive all the way to Texas made which was little over and hour and 20 and almost all the way home the trans quit.

Ended up getting 2 kinetik hc2400's and some 0/1 knukonceptz wire. Turns out they fit in the jumpseat location with some cutting and now my alternator is my weakest link since it can't keep all 3 batts charged for anything lol. Here's some pics. And it's messy so be kind, I am trying to make it to a show for the first time and hope to compete or atleast get a number.

I ran 0/1 from alt to battery + and 1 from battery - to factory grounding spot on frame below battery and the another to the factory ground strap from engine block to firewall to the alternator casing. Works great

I've been working and lazy but hoping to get these damn monsters in there this weekend. Should I expect a big increase in the output of my system?

/\ that's pretty much what 2 hc-2400's is going to look like in my little truck lol

Yea I know that. But for a week or 2 it will be fine until I figure out what battery I can get up front. And I'll have a battery tender plugged in at all times when parked to keep everything topped off

Im about to install 2 kinetik hc-2400's in the back of my s10 (inside the jumpseat compartment if they fit) they will be stacked and linked with 1/0 knu koncepts wire. I'm not sure if I should do my 0/1 gauge run to them from the alternator directly or from the front battery. I'll be running the stock alternator and stock type battery in the front until I figure out exactly what alt and what size battery I can fit in the front. I'm running a kicker zx1500.1 powering a single dc level 5 18" sub off stock everything with only big 3 done and I have pretty bad voltage drops. I've also been looking at everyones opinion on battery isolators and seems I don't need one. But I'd like to know for sure. So any help on how I should wire these batts in would be great.

Stock alternator and Walmart battery lol. And the door speakers are crappy no name 6.5's in door and no name 4x6 in dash on head unit with bass turned all the way down. Not sure why they sound so good. Next up will be a better alternator and second battery, then components for doors and better 4x6 plates and 4 channel amp

Thanks man! One more vid

Still have cadence amp? How much shipped to 77356?

No love? Is it that bad? I tried hard lol

Got it put in with a temporary false floor. Sounds way better but can't turn it up yet since it hasn't cured 24hrs. My underpowered amp Who needs a blow through? Lol

Yea, pretty much. I've thrown together shitty sealed boxes for temp use on crappy subs. This is way out there but I'm lucky to have an uncle that's a carpenter with every tool I needed and skills to make everything fit great and not come apart on me. Time will tell if we did it right. Here it is drying on the second coat of rust oleum bed liner that we rolled on

Well it's almost done, still need to bed liner it. Started at 8am. It's now 3:40 pm. It's hot as fuck and I'm exhausted. Here's some pics There we go. It fits. Still have to make a shelf for it to sit on and finish filling holes and sanding and finish letting everything cure before I can see how it sounds. But I think we did a pretty good job for my first box build that wasn't scrap particle board and sealed with no specs in mind lol.