motocross593

Level 4 18 48416

how much would a d3400 be? cuz i cant find a price...i see kinetik makes a HC2400...which is 2600 amps...for $300. would the XS be cheaper?

my buddy told me it should b at 14.4. so i thought it was low. but mine used to be higher. around 14.1 or when i let my car sit overnight. and i hop in. itll be at 14.1 or 14.2 but then it drops to usually 13.5ish

i have 2 of the big 3 down in 0 gauge...i ran out and couldnt do the engine to battery (-) could i just use a optima redtop? my alternator is only charging at 13.4 on my Cap right now...so im positive its takin a shit on me. ive been bangin on it for almost a yr now. Get more 0awg wire, finish up the Big 3. I haven't had experience with Optima, I normally suggest XS Power batteries to anyone looking to upgrade. what size XS do u think would be good?

i have 2 of the big 3 down in 0 gauge...i ran out and couldnt do the engine to battery (-) could i just use a optima redtop? my alternator is only charging at 13.4 on my Cap right now...so im positive its takin a shit on me. ive been bangin on it for almost a yr now.

jus dunno if i should get it used or not. and do u kno of any sites for HO alt's under $200? somwhere around 200 amp

so i can use a DMM and a 33htz test tone to see what the voltages are at on the speaker terminals? and the clipping is with an o-scope correct? Basically, but check the voltage at the amp, no speakers hooked up. Also, once you set the voltages right, if you use an o-scope the check for clipping and you have to adjust the gains, gotta go back and match them again. AQ has some nice amps, so does sundown, dc audio...lots of nice amps that are cheaper than the RF amps. None of them have cp though! But you won't be disappointed in an of what I listed. looked into a DC 2k...shipped to me for 595....dont rlly wanna spend tht much. i saw a used t1500 on Craigslist for 300. rlly thinkin about it. but idk. id like a warranty. i was only looking to spend 300-ish. whats your word on a hifonics BRZ1700.1 and BRZ2100.1 would the 1700 actually put out about that much true RMS or should i go for the 2100? those are decently cheaper. what do u think about the quality tho

Then it's probably a gain issue because you're using two amps. One gain may be slightly higher than the other i just dont get why one amp picks up the lows better...im using the older gray zx750...and a new 2010 zx750(black one) could there be a diff between them in power and shit? Yes. This is the problem. You set your gains wrong and the amps are different. FML. i jus wanna sell em both. and get a RF t-1500. run it at 1 ohm. If you did this, you would not be disappointed i had a RF p.1000.1 but then i thought 2 zx750's would be louder...but i fucked myself over now...i just sold my p.1000.1 to my buddy. i had em pushin around 1200rms from tht RF amp. but i was lookin for a wee bit more. any suggestions on a good cheaper amp than a t-1500? but still gets me around a true 1500RMS

what would u reccomend for bout 1600 RMS at 1 ohm? that is cheaper then RF

so i can use a DMM and a 33htz test tone to see what the voltages are at on the speaker terminals? and the clipping is with an o-scope correct?

Then it's probably a gain issue because you're using two amps. One gain may be slightly higher than the other i just dont get why one amp picks up the lows better...im using the older gray zx750...and a new 2010 zx750(black one) could there be a diff between them in power and shit? Yes. This is the problem. You set your gains wrong and the amps are different. FML. i jus wanna sell em both. and get a RF t-1500. run it at 1 ohm.

the one furthest from port...it also has the newer 2010 zx750 pushin it. and it is also the first in the line for my rca's...is it alright to use the pass-thru/ output to go to the 2nd amp. or would i be better off using a splitter? and also. how do i set the gains good then?

Then it's probably a gain issue because you're using two amps. One gain may be slightly higher than the other i just dont get why one amp picks up the lows better...im using the older gray zx750...and a new 2010 zx750(black one) could there be a diff between them in power and shit?

set the gains by ear. no distortion. could prob turn em up more. but i get too much voltage drop. need a new fuckin alternator and extrra battery

http://tinypic.com/r/2r3c8xw/7 not an L shaped port...just a slot. aproxx 17 inches deep...15 inches tall x 3 inches wide

<a href="http://tinypic.com?ref=2r3c8xw" target="_blank"><img src="http://i52.tinypic.com/2r3c8xw.jpg" border="0" alt="Image and video hosting by TinyPic"></a> not an L shaped port...just a slot. aproxx 17 inches deep...15 inches tall x 3 inches wide

ported, tuned to 33 hz gains are about half way up. no bass boost. subsonic filter is on. and htz on amp are roughly 60 i think

i just built a box. roughly 5.25 cubes. for my 2 kicker L7 12's i had to put the subs pretty close together. about an inch apart. now if i unhook one of my amps. (im running 2 zx750's) i still get the other sub to move. and it has a punch behind it. kinda like its picking up a signal from the other subs magnet. its also making a slapping noise, and idk wtf is wrong. jus wondering in anyone has any input for me. does it hurt my subs to be too close? and i also cant seem to get the amps to run evenly. one sub always picks up lows better than the other :/ HELP PLEASEEE

ayeee CJ18. mind hittin me up with prices for those same subs. shipped to 48416 and 2 of the 15" lvl 4 XL please. and whatevr amp u think would be good to run the two of them

need price for two 12" level 4 and two 15" level 4 also a 2k amp. zip code is 48416

can u get me a price on one level 5 15" shipped to 48416 and what do u reccomend on powering it with. how would a hifonics brutus 2608.1 do? any reccomendations on wiring and electrical work upgrading?