-
Posts
2270 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Media Demo
Store
Collections
Videos
Posts posted by Amart88
-
-
-
I've watched a freind play it for quite a while. Seemed kind of empty/grindy to me. a lot of running around not really accomplishing anything. I will also wait and see.
-
+1Jungleslut that was very disrespectful of you!
Airborne submit your form as to what you're looking for. Seth or some will get back to you within a couple of days.
+2 Was kind of uncalled for.
-
-
-
Slow for me also. Takes 30 or more seconds to load the site.
-
I would get some flat aluminum bar and put a 90 degree bend in it. make your own.
-
Since May 2011.
Nova Scotia, Canada.
This site has tought me endless amounts about car audio. Have learned so much since 2011.
Also nice to be able to help some people that were in the same situation.
-
-
I see lime green. Hint of yellow.
-
Email is usually your best form of contact especially for a possible warranty issue.
I did message him on facebook and gave him a link to this thread so Im sure he will pop in here when ever he sees the message.
Thanks, I just emailed him @ D'amore engineering also.
-
Email Tonay and see what he has to say.
Yeah, I may give that a go.
-
Hey, I've had my DD-1 now for over a year, its is an early model that is signed on the back. I just finished making a case for my dd-1 and cc-1. And every time I open the case, the DD-1 was on. So, i checked to make sure nothing was touvhing the on switch and there was plenty of room above it. I then set it by itself on the table. pressed off button and and around 2 mins in, it turns itself on. I have done this 4 times in a row now same result. Brand new battery.
I'm not sure what this could be. As everyone I have asked never heard of it before. It is working fine other than that from what i can tell.
Thanks.
EDIT: I left it alone after it turns on, it will not shut itself off now either. 20 mins and its still on. Also, when i turn it on/off it makes a small electrical squeaking sound from inside.
-
One, as stated Toyotas do charge low, It is a 2011 so also VERY likely it has some sort of PCM controlled voltage. Which is not the Alternators fault.
Two, As also stated, HO alternators often put out less at idle because their most output occurs at higher RMPs
Three. You can clamp it all you want at idle. No alts put out their rated power if there is nothing turned on to draw that big power.
-
I would not use it on fiberglassed panels. It would not be needed. Deadener is mostly used on large flat areas to reduce the panels resonance. Fiberglass panels are usually curved and do not resonate in that way.
If anything, Closed cell foam would reduce the transfer of sound throgh the material. ie. road noise.
-
Im not set on any specific brand. Just trying to maximize the performance from the sub while its running @ 2 ohms.
thanks for idea
Nows a good time to get at the sub. It is not going to last forever in there. It will need to be removes at some point.
-
What's sealed of in the trunk?
-
For the cost of that amp, you are wasting money running it at 2 ohm.
As bbeljefe had said, You may be better off going with a 2500 or 3500 at 1 ohm. More for your money.
-
Better keep that shit irrigated with saline and nice and clean and lots of antibiotic ointment. Punctures can get terrible infections
Thats what it stared out as.
I got a small cut on my finger and it spread up my arm as cellulitis. Had to stay on IV for 4 days and I am still on Antibiotics. It abcessed and had to be manually cut out. Thus the hole. I keep it wrapped and taken care of. I go back tomorrow for a follow up.
-
What happened to my arm last week. This is what dual alternators got me. It's about 1/2inch deep
-
-
That looks really nice dude. Looks like it was meant to be there.
Nice job!
-
^^
Indeed.
I have ordered many things from them. Their shipping is top notch. 3-4 days and I live in Canada. Most things from other places take weeks.
-
I always use rubbing alcohol.
You don't want to use anything citrus. It will leave an oily residue behind.
Castrol Super clean will work also.
D7500 just sitting in the garage question.
in XS Power Batteries / Chargers! (and other stuff too)
Posted
if it's still at 12.6 you should be ok. Just put in on the charger for a while.