dmurria78244

I know u probably have done this all ready, but if you haven't go with a X-Pipe, I reccomend the Flowmasters Super 40s or Super 44s.

Oh yea I usually have 4 people in the car and I'm going to have 4-12s, and 3 amps maybe 1 or 2 batteries

Hello I'm going to buy on 98-00 Town Car and was wondering how much lift I need to have it tucked on 26s with no cut I'm going to be running a 305-30-26 tire and dont want to be crazy high.

You think if I supercharge it I can get the mpg back up though? Since the engine will have to work less harder with the extra power.

I know it's a fuse, but I couldn't explain it correctly.

Really? Why is that? I'd say should have, especially for inexperienced people. (IE: ANYONE THAT HAS TO ASK ANY QUESTIONS) Because the rear batteries may try to transfer power to the front and they will collide or something like that, I read about it I can't remember exactky what they said but it's good to have two fuse for the protection.

Also how much will my mpg decrease with the quad alternators.

I was going to put fuses close to the rear bank too. Yes all my wiring is going to be 1/0.

I was going to ground to alts I just forgot to put it up there also should I increase the runs to engine block or just increase it to 1/0

Where on the busbar should I mount the grounds going to the frame(middle or end with all other grounds or what)?

Where should I mount the grounds going to the frame on the busbar?

Alright, would you happen to know what accesorry I'm going to need to mount the busbar to the XS Power 6500s or will it just go straight on, and is their anyone on here that makes custom busbars?

I didn't know I needed to ground from the rear, but how would you reccomend grounding the rear batteries(from the bus bar or what).

Ok I'm going to be wiring up a new system soon and was wanting some other people opions on if it is right also what should I change. Also BAMF 2600 are going to be Rockford Fosgate Power T600-2. Stetsom 14k2 Is going to be wired down to 1ohm pushing 4 Fi BTL 18s. Rockford Fosgate Power T600-2 is going to be wired down to 2ohm pushing a Hybrid Audio Clarus 2 way components set per channel.