jeffrm

Ive got a spl-labs wireless meter only 2 weeks old used once. PM me for more info

Thanks steve you the man

Thats why I said IF POSSIBLE!!!

Order #100001667, ordered dd-1 and cc-1 could you sign both and stickers too if possible please, thanks steve

Found the video on youtube and ordered the dd-1 and cc-1

Im hopefully fixing to get the dd-1 and maybe the cc-1, and I was wandering how to do it if ive got the rca's run like this: h.u.----rca knob----line driver----amp. My h.u. says it puts out 2.0v and amp can take 6.0v.

Hopefully I can get this box tested soon to see if it can do good for spl. If not ill build a box with interchangeable ports so if I want to compete I can, but at the same time I could change the port out and be a ground pounder

And my advice on a spray on glue for carpet is 3M super trim adhesive. After I put the carpet on the dust caps I checked to see how good it held and almost tore the dust cap apart. But the only downside is its like 22 bucks a can.

I got this camo from wal-mart its like 13bucks for a 3ft x 6ft roll

And this isnt a spl box its supposed to be a ground pounding mid-30hz box

I had just got done replacing the lights under the dash so the seat was pushed back some

this is what everythings goin in. you dont see alot of trucks that look like this with camo on the inside and i might use these dustcaps once everything is done

thanks man most of the accent pieces in my truck are camo

this box was built by me. i got it built put my subs in and it was tuned way to high. put the dimensions into torres for each side and it was 60hz. so since the box was done all i could do to it to get it to work was add a 3in wide piece to the port. so now the part of the port that goes back is 3in wide and the back L part of the port is 6in wide.(couldnt get behind it with the top on). not sure how to figure tuning now but it does better than the 60hz that it was. most likely ill be building another box unless i can fix this one? Any suggestions?

So do you think this box is fixable

the spot where it opens into the port is 6in too

how do you measure port length for a port in the center that has a 90* turn off each side

I was thinking that too. I may try to make it so the port is 3in wide all the way through

From the looks of it im gonna have to build a new box.

i think it is supposed to. i didnt realize that but i did some changes and its now in between the port area range. i had to add an inch to the width and 10" to the length and it gave me 34hz.

ok tell me if these seem right. the picture of the box is 6in longer than my original and different port design.

im wanting the tuning to be best for musical. down and dirty wicked bass

51.5in long x 17.5in tall x 22in deep

the way ive been told to figure port length is: start of port to back wall+side wall to end of port-width of port and the port is currently 6in all the through

by the way this was my first box build