JP Fabrication

Hydro graphic dip

190 hours in and I have my first piece installed for good. I'm on a roll now. (The subs were swapped out for 10W3's)

There will be a reverse image camera hooked up to the monitor on aux 1 for my view view mirror. An iPod will be on aux 2 for photos or videos. Audio input will be through the Ai port on X-001.

I changed up the mounting of the actuator by clocking it 45 degrees and raising the pivot point of the lever. I'm going to add a headliner in addition to the aluminum roof and a Chevy Blazer overhead console. By doing this the actuator will be completely hidden.

After doing installs for the past couple of years in ALL of friend's Side by Sides, it is finally my turn to do my own install on my recently purchased RZR. The difference in this install is labor will not be a limiting factor:D First off, the factory cage, seats and seatbelts where trashed and replaced with a custom cage br SDR Motorsports, seats by Jettrim, and Crow 5 point Y3" harnesses. There will be a linear actuated light bar contolled by the dual horn buttons on the Momo steering wheel. (In these pics the cage, aluminum doors and aluminum roof are not done) On to the good stuff. Product to be installed: /////ALPINE iDA-X001 PDX-2.150 PDX-1.1000 (2)SPX-17REF (2)SWS-1023D-These were quickly swapped out for 10W3's TME-M750A Other product to be installed as of right now, Optima yellow top, Lowrance Global Map 3500c GPS, four 4" HIDS, and a long travel kit.