JP Fabrication
-
Posts
215 -
Joined
-
Last visited
About JP Fabrication
- Birthday November 4
Recent Profile Visitors
3249 profile views
JP Fabrication's Achievements
-
30 pin to RCA So my guess would to use painters tape to cover the EQ volume knob and the face of the EQ all the way around the volume knob and make reference marks on both the knob and eq when distortion kicks in?
-
How do I properly set the amp gains using the DD-1 without a deck with volume numbers to use as reference for distortion? I have an iPad as the only source going from the 30 pin to rca to an Audio Control Three.2 EQ to my amps. I have searched but found nothing that will help me out. I found Steve's Youtube vid showing how to adjust the gains with an iPad as the source but he was running through a deck where the volume numbers were used for reference.
-
Killer? Are you going to make it to Glamis this season? What are on the mods list for the trailer? Solar, invertor, power tongue jack?
-
Looks great so far. I relocated my speedo and switcheskn both my RZR 800 and XP900 to make room for my Lowrance GPS. Any plans on making to Glamis next season?
-
Rand across this on Graig's List-http://losangeles.craigslist.org/sfv/ele/3597143316.html
-
Smart - I planned on setting stuff for the retards around here and their sony xplode walmart crap
-
-
Quarter panels, roof, and trunk all received deadening. We also had the headliner and visors wrapped in black suede After I was done with the install I took it to The SoundMan in Santa Clarita were Doug and Rafa took care of an input issue and then tuned the Bit Ten.
-
] I also made her a stealth cover incase she ever wanted to enter the rookie class to see how the system does.
-
Smoothed out with Rage Gold, mixture of Marglass and resin coated entire inside of enclosure along with a layer of deadening. A grill was made with breathable carpet The rear parcel shlef was vented and wrapped with grill cloth The JLHD 900/5 and the Bit Ten were mounted under the passenger seat
-
The sub enclosure area tapped off and measured for .65cuft Layed up to 1/4" of mat Cured and trimmed to desired shape. Flush mount speaker ring attached and felt stretched Resined, layed up with mat, and a coat of Marglass Cleaning up the edges
-
The door skin, door panel, and door card received a deadening. 4G ran through right side cowl.
-
Aiming tweeters Grill cloth stretched, resined, smoothed out with Rage Gold Sent out to get wrapped and stitched Some deadening was added. Milkshake mixture of resin, Marglass and Rage Gold poured into the tweeter pod. Wired up.
-
Here is my long time friend's new Fiat 500 she recently purchased. She was happy with the factory headunit with the Bluetooth but the rest of the system needed to go. I did this install over a four month period when I had free time. Audison Bit Ten JLHD 900/5 Zapco RH-16.2 6.5" Reference-active ALPINE SWR-1042D The bass control knob was mounted to the left of the steering wheel.
-
I charge the Optima while at camp using my trailer generator and battery charger.
.gif){kind=small}