Rav4 System Build

[CaptainPooPyPantz]

Here is My System Build . . . i dont have too many Step by Step pictures because mostly i work alone on my system . . . but the job gets done :-)

http://www.facebook....29&l=7d932517b8

Edited April 23, 2011 by CaptainPooPyPantz

[dkahns51]

Here My System Build . . . i dont have to many Step by Step pictures because mostly i work alone on my system . . . but the job gets done :-)

http://www.facebook.com/media/set/fbx/?set=a.102875479792423.6033.100002099140329&l=7d932517b8

Nice setup!. Hope you got a nice alarm on there with all that car audio advertising you got going on there

[CaptainPooPyPantz]

Here My System Build . . . i dont have to many Step by Step pictures because mostly i work alone on my system . . . but the job gets done :-)

http://www.facebook....29&l=7d932517b8

Nice setup!. Hope you got a nice alarm on there with all that car audio advertising you got going on there

Haha Thanks , . . no i dont have a Alarm , my car stays in the garage and i live in a very small town everyone know everyone around here , we have a very low crime rate

[CaptainPooPyPantz]

[fecupe2001]

Very nice, start thinking on adding another sub and more power hehe, that´s always fun

[CaptainPooPyPantz]

Very nice, start thinking on adding another sub and more power hehe, that´s always fun

Hey , Thanks man . . .

i am thinking of putting more power to it , maybe 1500rms or so . . . right now its only getting 1000rms sub is dual 1 wired to series , but i want to upgrade to a rockford fosgate t1500-1bdcp.

And about adding more subs??? . . . .Nahh i would not like the extra weight . i,m good with just one sub

[knowledge]

nice setup man, i like them mtx 9500's how does it sound and how you attached the amp to the panel?

[CaptainPooPyPantz]

nice setup man, i like them mtx 9500's how does it sound and how you attached the amp to the panel?

Thanks , i'm glad you like :-)

9500 was a great subwoofer it played very clean .

But i love caraudio too much to hang around on one brand so i sold it and went to the next.

the AQ Shakes me harder IMO but it could also be the enclosure it is in , if the 9500 was in that enclosure it would really pound.

The amp was not that hard to place there . . the panel came off easy just 4 screws were holding it in there . . . so i took it out , did some measuring drilled some holes in it , just so the 7mm bolt could pass in it and would not fall off when i try to put the panel back , then i put the amp on there and bolted it down with the nuts.