kenwood excelon x1200m amp

[joemon]

any1 know anything bout these amps?

I kno in the manual is has in there that u can have a master and slave to use for the bass remote.

So I was wondering if any1 wound kno exactly how to do this?

(Use 1 bass knob for 2 amps?)

Idk if this would b called strapping or not but I tried doing this but I can only get 1 amp to gain with the remote and the other amp just stays at the same volume.

Any help plz

(And has any1 had this amp b4 and how do u guys feel bout these amps?)

[TRTC360]

any1 know anything bout these amps?

I kno in the manual is has in there that u can have a master and slave to use for the bass remote.

So I was wondering if any1 wound kno exactly how to do this?

(Use 1 bass knob for 2 amps?)

Idk if this would b called strapping or not but I tried doing this but I can only get 1 amp to gain with the remote and the other amp just stays at the same volume.

Any help plz

(And has any1 had this amp b4 and how do u guys feel bout these amps?)

if you have two of the same amps and you're trying to strap them or link them, the amp hooked up to the bass knob should be set at master and the other at slave, the master amps gain settings, bass boost, subsonic, etc should be copied by the slave amp, no tuning has to be done on the slave amp. hope that helped a little.

[joemon]

Ya I tried that and only the master amp gains from the remote and the slave amp stays the same volume.

And the remote is a phone line jack type of knob