10k+ DDZs No batteries, Big Cap bank, custom built alt, daily driver **153 sealed legal trunk holding 15 volts ish on music**

[purplesyrup]

nice!

[Bump4life]

and finally on to the current build!! DD 9512s!!

all equipment in my build is listed in my sig!! check it out!!

I will start with pics of equipment!! I built these subs myself, from motor up. ordered all the parts and got em going. it was actually a very fun part of this project.

9500 f motors!!

i ordered all new soft parts. these are the ones they currently use on the i motors! gotta love fresh baskets and recone kits!! some nice kevlar kaps too!!

[Bump4life]

i put my custom kaps on then. go blue!!

[Bump4life]

added a RF T600-4 for my polk highs. This will give me about 170 rms on each of my channels to each polk!!

birthsheet says 198x4@ 2 ohms!! 791 rms total!! polks are 2.7 ohm.

for those who can read upside down

guts!!

it says tony on wrench or what ever guy is holding!!

and i have a parrot on board!!

temp hook up. for sound check!

[Bump4life]

next up is the wiring!! redid all CCA wiring i had left in car to Knu Kolossus OFC! so Big 3 is done in 0 gauge OFC. then i added 2 extra engine grounds to frame which solved my light dimming problem. all speaker wiring is obviously OFC. im running 16 gauge to all my polks. 12 gauge to my DD W6.5 midbass( those are being run on the JL 400.4 which is in rear deck, 200 rms to each) and 8 gauge Karma SS to subs!

4 gauge knu OFC to each highs amp and 0 gauge knu OFC to M1c.

here are some pics!!

the wiring

1 of my engine to frame grounds

hard to see, but alt casing to frame ground

alt line and engine ground.

under view of alt casing to frame ground

tranny to frame ground. ( this is where the stock engine ground was.) sorry very hard to see if you can at all.

soldering 0 with the torch!!

sub amp power and ground

bare trunk

more updates tomorrow! im tired and there are way too many pics to post still!!

[Socky]

Looking good man, just went through the whole process lol.

[Bump4life]

Looking good man, just went through the whole process lol.

thanks ill have more up today after i completely finish the car!! gotta finish it for the show that is this weekend!!

[Bump4life]

here is some more pics coming up for all of my followers and peeps tuned in on this build.

[Bump4life]

hello new battery!!!

xs D5100

all charged up!!

this is where bat will go and be connected!!! charging at 14.1 before bat connected!!

more wiring under the floor. behind the scenes!! all the speaker wire and rcas and bass knob going through here in addition to cd to mp3 adapter fo rmy car!!

yea i work through the night to get this done!!

2 hours after charger. not bad. but usually drops to around 12.8, same as D5100. gotta love a mercedes batt

area ready for xs power!!

more soldering or 0 gauge!!

and that is pretty much all the electrical upgrades. the car lloks like this so far!!

that is a little messy for my tastes. we can do womething about that later. time to star this sub box and add the relay in to finish wiring!!

[purplesyrup]

looking good