MadDrunx' build log 6 10's, 4 tweets for mids&highs 2 15's for bass.

[notorious97200]

You will be loud as f... k !!!

[mad drunx]

At this point I put resin on them, and then sanded them down.I put three layers of glass on the inside, and three on the outside.

Edited February 21, 2012 by mad drunx

[mad drunx]

I ground all the nipples and itchy stuff off.That is the worst part about fiberglass IMO.After the glass I mixed up some duraglass for the big dips and gaps.I spread it on sanded it down,and then did the same with bondo.

The green stuff is the duraglass,the pinkish is the bondo.

[FroznBeavrBALLs]

doors looking good. these will be some loud doors. lol

[mad drunx]

After all the bondo was done I flex primed it with three coats,then sanded it down with 240.Then I flex primed it again with three more coats.We put this stuff in our primer called plasticiser ,which makes the primer and clear be able to bend.I call it flex for short,I used that because of the plastic bending on top of the panels.This picture is during sanding after the first coats.

This is the second set of primer coats.

The whole panel was textured,and I didn't wan't that so I primed it and sanded it to look like the rest of the panel.

Nice and slick.

[mad drunx]

I didn't want to wrap the doors,but I wanted them to match the interior.So I went with a grey that I made by pouring tints in to a cup until the color was close.I sanded them with 320,then flex sealed them.I sprayed my base, then I matte flex cleared them,so they weren't to shinny.Her they are all wired up ready to go.

[mad drunx]

I'm running two runs of 0 gauge from front to back,And two 0 Gauge grounds from both batteries to frame.There is a fuse on each end of every power wire in the truck.I also soldiered all the terminals to the wire.

Here's a pic of the grounds.Then a pic of how I grounded them to the frame.And also a pic of most of the wire before I started.

Here's the truck gutted to run all the power, rca's and speaker wire.

[mad drunx]

Here's the platform for the back KInetik 2000,and also where the grounds come in.And then a pic of it bedlinered.

I built a platform for everything to mount to,and I'll bedliner it also.

[mad drunx]

Kinetik 2000,and extra wire for the bass amp.

In the hole all wired up.

[mad drunx]

The false bottom is bedlinered.

All panel in except for the seat,because I'm lazy.

I did it like this so if I ever trade the truck in I won't have to buy a bunch of panels.