glockman513 Posted December 7, 2012 Author Report Share Posted December 7, 2012 Recones. Also. Remember that you don't want to run two different subs, so you would have to buy two possibly 4 new drivers to keep them all the same What would happen if I ran 2 different makes of drivers in it? I obviously would make sure they the same ohm and power ratings. If you're feeling DOWN & OUT, it's time to get UP & IN Link to comment Share on other sites More sharing options...
RCP Audio Posted December 7, 2012 Report Share Posted December 7, 2012 All drivers act different. Even if they are the same ratings. They sound different aswel. And have different Xmas. Many different reasons not to do it PSN: Rcp_soundz Good rule of thump is go by what fuse size is being used in these amps. The higher the more amperage it pulls, this is what I look at. I'll stick a 300 amp fuse in a potato and sell it to you for $2k. 1991 Mazda 323VERY small build thread here: http://www.stevemead...23-small-build/ Link to comment Share on other sites More sharing options...
iceman1575 Posted December 10, 2012 Report Share Posted December 10, 2012 If you're going to stick with them, recone them with factory stock recones. Just as an FYI, I had a set of the single 18" boxes, they are some of the worst sounding PA subs IMHO. Way too boomy and rumbly, not enough definition, and you had to give them too much power to get any real volume with them. POTATO! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.