Slow 07 Trailblazer Updated with new set up

[mmets]

[mmets]

[mmets]

[mmets]

Now for my baffle I was looking for something heavy but really dont have much in the garage so was stacking random crap on it. So this is what i ended up with

Of course once I get this on there my son, who is 14, looks at me and says "Hey dad, you wanna put some cat littler on there too?" lol ..............Smart A@#

As for the box there is some overlap around a good amount of it. I am going to get the router out and clean it all up so its even. I use to try to just cut everything but for whatever reason it was never perfect. So glad I bought a router a couple years ago to clean all that up. More updates as they come...........

[kicker8940]

Looking Good so far!!

This is probably a dumb question,but i noticed some of the joints don't line up.

Did you leave them like that so you can use a router with a flush trim bit and even them up.

Edit: Looks you answered my question before i posted.

[mmets]

Yeah that was my last post above yours bro. I think its easier to get everything clean that way. Would have started to toss the threaded rod in there but i dont have the right drill bit so to lowes tomorrow I go lol. Thanks for the desing again!

PS.......If it sounds bad I'm tossing your under the bus LMAO ......................kidding

[Tecomah]

Looking good. I was wondering why it was all uneven lol. That was smart. I should have done that for my box

[kicker8940]

That's fine then you back over me to make sure the job is done right.

[mmets]

I wont run you over, its all about experimenting and trying something new

[mmets]

So did a little work this afternoon and was trying to get this box going but just trying to take it slow for now. Added some of the rod, still need to do two on each side from the top to bottom, need to get the top holes cut, little sanding, get the washers sealed, resin the corners and some out side area's since I will give a go at painting this beast here.

Went to use my cut off wheel and the end of my airline broke so need to pick up a new connector. At least I didn't get hit with it.

And a reason I don't like MDF right now..........

Next time I'll try to find some good birch. Only stuff I have found so far was 9 ply and would like to use 11 if I'm going that route. I'll try to get a little more done tomorrow when I get back from the DMV if I don't kill no one up there...Long story.