Kade Posted June 24, 2014 Report Share Posted June 24, 2014 I have this door harness instead of wires going into directly to components in the doors. Where can I find pins to get my aftermarket speaker wire to my speakers? Or should I just drill holes in the harness? I have less than half of the harness ports used by stock items. 2009 Dodge Caliber SXT (Silver) Deck: Pioneer X3600BHS Amps: RF P1000X5 Front: RF P16-S Rear: RF P1694 Subs: 1 RF P3D2-10 Cabling: Stinger 6 channel RCA, RF 4gauge kit, SkyHighCarAudio 16gauge speaker wire. Build Log: http://www.stevemeadedesigns.com/board/topic/188246-caliber-build Professional Networking: https://www.linkedin.com/in/kade-mallett-332b8a104 Link to comment Share on other sites More sharing options...
g2shuck Posted June 26, 2014 Report Share Posted June 26, 2014 I have always seen ugh just drill holes where the missing pinswould be. Run the wire through the holes and silicone it. 2000 Toyota Camry With Sealed Off Trunk Sky High OFC Wiring DC Power 270 XP Alt AQ 2200 Sub Amp Two DC Level 4 m2 12s 80 Mil Murdetmat Gathering Parts For Wall Build. Team DC Audio 2014 Member Link to comment Share on other sites More sharing options...
youngbass98 Posted June 26, 2014 Report Share Posted June 26, 2014 edit: didn't read 06 monte carlo 2 12 rockford p3s soundstream rubicon 2500 crescendo audio mezzo 6.5 ct sounds 125.4 execution audio and shca wiring 2 xs d3400 on stock alt Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.