Nokia Icon "clamp" test

[ROLEXrifleman]

This is part one because I need the baseline to see what my Fiio E6 puts out. Nothing more than just because I wanna know numbers. I don't have you tube video production value or anything like that. I take pics. If you don't think I know what i'm doing that's fine just leave the thread. Take the info for what it's worth. When you spend the coin on the equipment then you can do it the way you want.

Nokia Icon windows based phone

DD-1 test tracks 1 and 2 (40hz and 1khz @ odb) only

50ohm and 25 ohm loads, this was used to simulate some of the lower impedance headphones out there. in addition a no load measurement was taken

I tried to use the DD-1 and AMM-1 but they don't read this low.

so here ya go:

and the results..... BTW, didnt matter if it was at 40hz or 1khz... the voltage was teh same..

No load:

@ 50ohm:

@25ohm

I'll run the Fiio E6 tomorrow