Jump to content

Tweeter in parallel with coaxial. Does tweeter RMS need to match coaxial?


Recommended Posts

On 4/9/2021 at 2:56 PM, RazorRust said:

Hmmm. I was under the impression the amp would not see a 2 ohm load because the tweeters are only operating at the higher frequencies.

 

Anyone know how I could quieten down the tweeters if they are too loud?

 

This is true when you are talking about component speakers. That is how you can have a 4 ohm tweeter and a 4 ohm mid and the amp sees 4 ohms. You are still sending high frequencies to to both speakers in your case.

 

There are a bunch of terrible answers here. Your best bet is to not wire the tweeters up with that amp. Wiring tweeters on their own channel and the coax speakers on their own channel is not a solution, you will lose all stereo sound, although it probably won't hurt any equipment. Best bet is either to not use the tweeters and stick with the coax speakers (or replace them with a component set) or to buy an amp/replace your current amp with a 4 channel to run the tweeters. You can possibly run the tweets from the headunit though I'm not sure it would be worth the effort.

 

F150:

Stock :(

 

2019 Harley Road Glide:

Amp: TM400Xad - 4 channel 400 watt

Processor: DSR1

Fairing (Front) 6.5s -MMats PA601cx

Lid (Rear) 6x9s -  TMS69

 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...