vexproductions Posted July 6, 2008 Author Report Share Posted July 6, 2008 voltage issues. youre trying to run over 3k watts rms off of stock electrical the only thing stock is the alt i ran 2 runs of 1/0 to the back with 3 of the big blue tops Quote Link to comment Share on other sites More sharing options...
vexproductions Posted July 6, 2008 Author Report Share Posted July 6, 2008 and i didn't take the power from the stock batt i ran a separate leg from the alt..if that helps ????????? Quote Link to comment Share on other sites More sharing options...
ChevyBoy Posted July 6, 2008 Report Share Posted July 6, 2008 when your batteries drain, your alt cant push them. i think it might be voltage or a ground Quote Link to comment Share on other sites More sharing options...
Chris D Posted July 6, 2008 Report Share Posted July 6, 2008 The stock alt runs at what, 120 amp? If so you probably do have a big drop in voltage, do any of your lights dim? And is that with the car off, idling, or at around 2000 RPM? Quote Link to comment Share on other sites More sharing options...
vexproductions Posted July 6, 2008 Author Report Share Posted July 6, 2008 The stock alt runs at what, 120 amp? If so you probably do have a big drop in voltage, do any of your lights dim? And is that with the car off, idling, or at around 2000 RPM? very little dim on the lights and i dont know what amp is the stock alt and factory idil round 1000 Quote Link to comment Share on other sites More sharing options...
jmsonoma03 Posted July 6, 2008 Report Share Posted July 6, 2008 (edited) have you tried bypassing the 701 and the audiocontrol. run the rcas from the decks sub out directly to the amps.or make sure if you are running the decks ai-net into the 710 then to the amps that the switch under the radio is switched to ai-nit not standard. might be a signal problem not voltage esp if its at 13v and the headlights dont dim. Edited July 6, 2008 by jmsonoma03 Quote Link to comment Share on other sites More sharing options...
vexproductions Posted July 6, 2008 Author Report Share Posted July 6, 2008 have you tried bypassing the 701 and the audiocontrol. run the rcas from the decks sub out directly to the amps.or make sure if you are running the decks ai-net into the 710 then to the amps that the switch under the radio is switched to ai-nit not standard. might be a signal problem not voltage esp if its at 13v and the headlights dont dim. ya i checked and made sure its a i net i also tryed the bypass of the mvc and still the same thing but i didnt try to bypass the 701 . also i got the reading with the system jus playin reg i didnt try to meter it with it bumping ... to tell the trut i didnt think i would have bin a power problem... Quote Link to comment Share on other sites More sharing options...
jmsonoma03 Posted July 6, 2008 Report Share Posted July 6, 2008 switch it back to standard and bypass the 701 hopefully it works. Quote Link to comment Share on other sites More sharing options...
Jextel Posted July 7, 2008 Report Share Posted July 7, 2008 i had a problem similar to this and it was my RCA's(cheap ones)the solder pint became loose and weaken the signal... Quote http://www.cardomain.com/ride/3042878TEAM DEADLY HERTZ "GET LOUD OR DIE TRYIN"only the loudest will survive. Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.