Amplifier decisions HELP!!!!!

[skinneyfinney17]

So im stuck between a rock and a hard place there's two amps that i really like for my subs

im stuck betwen an Audiopipe AP30001d and a MB quart dsc2000.1D here are the specs

the subs im running are 2 Pioneer Premier TS-W3002D2 or D4 (depending on amplifier) 12's

http://www.sonicelectronix.com/item_16665_...TS-W3002D4.html

Audiopipe AP30001d

Features:

# Audiopipe 3000 Watt Mono Car Amplifier

# 1 0hm load stable

# output power (rms): 1800w@4 ohm or 2x600w,

3000w@2 ohm or 2x950w,

1500x2@1 ohm

# overload protection

# overheat protection

# variable low pass electronic crossover

# variable subsonic filter.

# built-in variable phase shift.

# 55 mm(h) x 176mm(v) x 710mm(l).

# 2.2 inches(h) x 6.9 inches(w) x 30 inches(l).

# distortions: <0.2% thd

# signal to noise ratio: 70db

# input level: 0.2-5v

# bass boost frequency: 30-80hz

# low pass filter: 40-180hz

# subsonic filter: 5-50hz

# frequency response: 8-180hz

MB Quart DSC2000.1D

# Discus Series Class D Monoblock Car Amplifier

# RMS Power Rating:

* 4 ohms: 500 watts x 1 chan.

* 2 ohms: 1000 watts x 1 chan.

* 1 ohm: 2000 watts x 1 chan.

# PWM (Pulse Width Modulated) MOSFET power supply

# Wired remote bass level control included

# LED power and protection indicators

# Tuned Bass EQ (0-9 dB bass boost at 45 Hz)

# Soft start sound

# Preamp RCA outputs

# DC, short, thermal, and overload protection circuitry

# Unbalanced RCA inputs

# Damping Factor: >180

# Variable input level control: 0.2V-0.6V

# Variable low-pass filter (35-250 Hz, 24 dB/octave)

# Subsonic Filter (15-35 Hz)

# Frequency response: 15-250 Hz

# Dimensions: 19.69"L x 9.45"W x 2.7H

and here are the two mids and highs amp im stuck between

mbquart dsc4125

http://www.sonicelectronix.com/item_13496_...t+DSC+4125.html

Audiopipe AQX300.4

http://www.caraudiodeals.com/audiopipe-aqx3004-p-2808.html

Help please i would like to stay with 1 brand

[Andrew2944r]

Audiopipe

[TeamNemesis_Jessie]

Audiopipe

x2

Edited October 8, 2009 by jessiew

[tehbert0]

you might have to be a little careful running the ap to those subs

[^/\Ro0Ki3/\^]

yea the Audiopipe is the best bet man

[P4killer_]

yea remeber the AP is dual mono and its 3000 bridged at 2 ohms so only d2's would work and itll be a bit high on the power if you actually produce 3k

Edited October 8, 2009 by P4killer_

[skinneyfinney17]

yea remeber the AP is dual mono and its 3000 bridged at 2 ohms so only d2's would work and itll be a bit high on the power if you actually produce 3k

do you think the subs cud handle 1500rms?

[tehbert0]

from my experience with them they had a tough time handling 1200 watts. if they start to get hot keep the bass boost down some

[skinneyfinney17]

from my experience with them they had a tough time handling 1200 watts. if they start to get hot keep the bass boost down some

wut do you think about the mids and high amp i kno the mbquart does rated im a little etchy about the audiopipe no one has used them yet

[corrie32]

i'ld get the MB Quart setup, they take up less space.