EricR Posted February 24, 2010 Report Share Posted February 24, 2010 I must have gotten lucky.Mine took 1Ω bridged at 10.3v and less than 10% THD fixed Quote i was thinking leave the 12 sitting in the box in the hole and duck tape from the bottom of the sub to the bottom of the baffle so the sub doesnt free air. would that work? Link to comment Share on other sites More sharing options...
MileSwimmer4444 Posted February 24, 2010 Report Share Posted February 24, 2010 i just bought a couple of these...cant wait to get em in!!!!!!! id say run it at 2 ohms...just so you dont have to deal with the possible difference in voltage across the two channels Quote 4 - 15 Sundown Z v.2 @ 35Hz 2 - AP3000D 2 - RF Power Punch 6.5 Comps 2 - RF Power Power 1 - Kinetic KHC2000 3 - Kinetic KHC2400 Iraggi 300A Knu Wiring Link to comment Share on other sites More sharing options...
fox_racin4 Posted February 24, 2010 Report Share Posted February 24, 2010 I must have gotten lucky.Mine took 1Ω bridged at 10.3v...... mine takes 1 ohm bridged as well without going into protect i just bought a couple of these...cant wait to get em in!!!!!!!id say run it at 2 ohms...just so you dont have to deal with the possible difference in voltage across the two channels ya... the voltage is diff on the 2 channels by about 4 or 5 volts ( mine were anyways ) Quote 1998 gmc extd cab 12 crossfire C710s 4 SAZ-4500s 3 Singer 400A altsbuncha mids/highs Team Asshole Link to comment Share on other sites More sharing options...
Bunker Posted February 24, 2010 Report Share Posted February 24, 2010 Mine run fine at 1 ohm voltage 14.6 - 14.0 I just have heating issues with mine. Quote J&T DESIGNS M5 4 Audioque 15's copper coils dropping Audiopipe, and picking up DB DRIVE OKUR Powermasters XS POWER Dropping MaxxSonics Pioneer Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.