Cdizzle Posted June 14, 2007 Report Share Posted June 14, 2007 Right now I have to kicker comp vr subs, they are dual 2 ohm subs and I have them set up to pull 4 ohms. I have one sub hooked up per channel, but I was wondering, it says that it is 300 watt rms @ 4ohms, I was wondering if I could put the subs on the same channel so they were pulling a 2 ohms load off one channel cause I was thinking it would RMS at about 350-400 watt @ 2 ohms, which would max out the subs. Should I switch it up to run 2 ohms off one channel, or keep it the same way I have it, one sub per channel? Damn Thiefs Link to comment Share on other sites More sharing options...
Cdizzle Posted June 14, 2007 Author Report Share Posted June 14, 2007 bump Damn Thiefs Link to comment Share on other sites More sharing options...
Cdizzle Posted June 14, 2007 Author Report Share Posted June 14, 2007 bumpity bump bump??? any one help before I call it quits for the night? Damn Thiefs Link to comment Share on other sites More sharing options...
Chris Posted June 14, 2007 Report Share Posted June 14, 2007 I'd keep them they way you have them bro. 4 15" FI Q D2's in 12 cubes tuned to 32hz 1- T1000.1bd's 3 Maxx 29 deep cycles 4 runs of 1/0 gauge -Big 3 -Trunk sealed off from the cabin Custom 15.8 dual-volt switching MLA module All in a CAR. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.