mel80

that is with single 148ah bank im going to step it up to 3 banks here soon as im switching form the five recoil 1200.1 amps to five slapz audio shock 5ks

something to this extent

bassed on v3 specs im going to guess ur going to want 3cft net and about 46sqinch of port , though u have room to play with port area , less sqinch of port = less port lenght so u can use that to play with ur box design to get it to fit int he car nicely , i would stay within the 36-50sqinch's of port though andthing smaller then 36sqinch is likley to have port noise

i also vote for last box design 3x x8's should be p retty dang loud i ran 4x e8 v6's for a while on 2 x 1200w amps and they got loud if i had to guess id say a solid 145ish in my car i never did get that setup metered before i went to 3x 12's in the trunk and then 5 12's in a flatwall int he same car my e8's were in a 4cft net box with 36inch of port area tunned to 32hz

bank worked great only ever saw voltage drop by 1-2 tenths from charging voltage as my alt heats up it drops voltage so when cold it was charging at 14.4 and i saw 14.2/3v when its hot i see 13.8 for charging voltage and only dropped to 13.6 at the lowest

will do should be putting it to the test this comming saturday going to a comp down in nevada

new lithium going in

yeah u gota model the sub and see my subs have a pre break in fs of 45 hz , they nail the nail the lows i can play all the way down to 22/23hz very loud this score wa sput up with a leaking enclosure btw

been a while but heres an update wall is repaired and holding so far though i did burn up my headway bank so i havent been able to give it fuull power yet .that being said i have 296ah of lev60 on the way along weith enough headway to rebuild my bank into a 128ah bank ontop of the 296 of lev60. my next basswars even is comming up on the 4th so well see how she does im looking for atleast 5db gains over what i put up with the leaking wall last time

my thought/plan atm is to cut some 2x4's to glue and screw in there , the rear wall is on a 13* angle so im thinking about rippipng some 2x4's on that 13* angle and glueing/screwing them to the floor and the back wall , and i can go 2 layers high which should be plenty.

1st and second in classes after i broke the wall was doing some demos in the 20-30hz range before i made my runs and blew the bottom seam on the back wall , sheared the pocket screws glue and brace right in half its all dbl walled too so now i gota figur eout how to repair it

seats are back in , lithium is installed back in the trunk cleaned up the amp wiring , few minor odds and ends to take care of before this weeknd