pcchris

i have them strapped right now 2 subs per linked pair ... used to be 1 sub per amp 4 hdc318s 1 300 amp iraggi alt (just found out about a sense wire and ran one to the battery (+) post last night with a 1a 200v diode inline 4 2608 brutus amps one maxxlink and one lil shuriken bt-100 thats been going strong for 3 yrs I just put bigger terminal screws on it and car went dead (battery probably never was getting charged as i had 6 0 gauges rigged on top each post) ive had this set up for three years...wanting to try something different I reconed 2 months ago used epoxy under and above the spider landing...I shortened my 38 hz port down to 34 hz (more excursion and im loving it) the epoxy i used during recone is holding up alot better than CA glue so far ...i think i can throw more power at em I know how to watch for clipping....

I have 4 brutus 2608s and a maxxlink that ive been running 3yrs now....getting bored with the setup and 4 Dual 2 subs Heres my evil plan.... I have the amps strapped and the manual says to not run them below 2ohms while strapped...well i know for sure they can as ive ran them at 0.5 each but not strapped I want to run all 4 subs wired into 1ohm total > into all 4 amps that are strapped 2x2.... to make things simple i tried to make a drawing with an online paint hope yall can see where im getting at basically one voicecoil at 1ohm (scratch that 0.5ohm i metioned in the pic).... 4 amps 2 pairs strapped into 1 coil thats 1ohm_ just wondering would the 2 added amps feed back into the first two? would the 1 ohm load split across all 4 amps? ....what problems could i be getting into doing this?... also i have jumper wires going from the (-) on the master into the (-) on the slave of each linked pair___ should i jump a wire from the other linked pairs (-) into the first when attempting this or leave them be and run 2 strapped pairs into virtually 1 coil???

I had this problem before check your RCA's, y-spliters and grounds

sorry just noticed that... thanx for letting me know bro heres the working link http://www.mediafire.com/?9651kzpy1rwqyuf

i posted this in general discussion yesterday__didn't get any replies :o/ ...so i figured its better off here... I'm a producer in Houston Tx Ive produced for many locals... one of my bigger productions Ive had a hand in was Boi I got so many by Young Problemz...(yeah it bassed) anyways check these 4 tracks out and let me know your honest opinions... the artist on the songs is Justo of Young Problemz extract them with winrar (Windows) or unrarX (Mac) http://www.mediafire.com/?9651kzpy1rwqyuf

NEW song from Justo of YoungProblemz (will be on his new mixtape SuMn CruCiAl dA LeAk) produced by >>ME(Djsmartguy)...... @DjSmartguy (on twitter) ---Download here--- http://tweetmysong.com/1st3m8 HIT 'EM___ www.twitter.com/justoyp YoungProblemzGang | Facebook

BUMP

is this box size okay for 4 18 hdc3s? or should i rebuild? someone told me rebuilding to 24 cubes will make a difference and that my current box is too small since they require 6 cubes a piece.... also im running 4 bxi 2608ds 1 bt80 shuriken batt 1 300 amp ho alt 2 runs of 0 +/- could my bass be sounding this way because i need more batt to feed my amps? i know i need more batt but my voltage doesn't seem to drop to hard...(according to the dash) so ive been putting off getting the other 3... my whole reason is because this setup is not creating the throat hurting pressure and air movement i intended ---so is this BOX, BATT or BOTH? Kranny my ports down the middle would that make a difference?

moved to bottom of post

moved to bottom

Ok i took the measurements of the box here goes _The Box_ 28" Deep 38" Tall 48" Wide _The Port_ 21" Deep ---(measured from where the port wall ends inside the box) 35" Tall ---(measured from inside the port) 9" Wide ---(measured from inside the port) and Its double layer 3/4 birch on all sides the port walls or double layered 3/4 too Whats the cube and tuning? its supposed to be 25 cubes and 36hz tuning let me know guys...

but thier sealed

im getting them for $70 a piece i just found the specs online thats all

http://www.batteriesinaflash.com/emergency-lighting/12v/12v-135ah-sealed-lead-acid-battery-universal-ub121350-40994 http://www.batteryte...2A5F4FA1495062C can i use 5 of these for a system capable of 10,000 watts

ok bet thanks everyone thanks ericR for findn prices too makes alot of since i know everyones like a been sayn that i had to let it sink in....ill get the box built__i was putn myself further away from my main goal__gettn the hdc3s in also where can i find the stinger spv70's that cheap 360 for 3 i looked them up and their around 3 bill apiece