troy

do they draw horrible amounts of current?

exactly the kinda info i wanted. what do you tink they actually put ut at one ohm?

looking at this for my new amp. Just wondering if anyone has had any problems with overheating and what not with the amp? it will be wired at 1 ohm and gains will be low

come on i need a new demo song

i need a few songs with sick bass lines. i kinda want rap or hip hop. i would like a deep bass line while at the same time loud.

you can get the whole album on some torrent sites but it is best to buy it.

another guy has told me this also^^^^^ what do i do to turn the amp down? just reduce the gain?

if it helps it will be going on a pair of cvrs. i dont really think 700rms will be safe^^^^

is there any thing a lil cheaper? im not so sure i wanna dump 350 into an amp at this moment? maybe 200-250.

just as title says. i would like a class d mono amp. somewhere close to 1000-1200 rms

what kinda kicker 18? if you want a sub just to make noise get the solo x. if not the fi

should work out. make sure its braced god though.

so you would take either the two of these over the two small amps? is it exactkly safe to put 600rms on a cvr?

port/ subs/sub back box biult to specs

i have a 750.1 for another set of cvrs but this is the dual 4 ohm coils so i can either get 2ohm x2 or 1ohm x1. maybe 250 tops.

it would actually be two 300.1s. one for each sub. i konw the newer model kenwood has a limit on the power it produces. it cuts out at 900. But do you have any suggestions for an amp then?

what is your opinion on a Kicker ZX300.1 for a pair of cvr's? I will have two of them one for each sub wired to 2 ohms. Or would i be better off getting one kenwood Kenwood KAC-9104D and wirng it to one ohm?

any references?

i am looking to get either a kicker zx850.2 or a kicker 550.2

kenwood amps are pretty reasonable. they are in the 75-200 dollar range depending on how much power you want.

depends on the ohm load of the amp and f you will have sufficent power and airspace for the third sub. you would have to run the amp bridged since it is a 2 channel amp. so you couldnt run a ohm load under 2

very there are many many people on here that use the stuff and its one of the biggest wires on the market

brand doesnt matter juts needs to be functional

knukonceptz is about as cheap as your gonna get. hit em up.

i know a 4 gauge block can accept 1/0 wire with the right terminals so maybe a 1/0 bloc kwoll accept it wiht the right terminal