Jump to content

fritosaregood

18+ All Access!
 View Profile  See their activity

  • Posts

    2708

  • Joined

  • Last visited

 Content Type 

Everything posted by fritosaregood

  1. fritosaregood
    if you just add them on to the set thats already there. youll be bringing the impedance down to 2 ohms. h/u's "arent" rated for 2 ohm stability. you could run into over heating problems
  2. fritosaregood
    That must only work for JL amps. i tried it on my sundown. I got that i needed 55 volts to get 3000rms at 1 ohm so i set it to that, but when i hooked the sub up and tested again my DMM went up closer to 80 volts. All that was changed was the sub was hooked up. same tone, same volume.
  3. fritosaregood
    well it just turned midnight here, and nothings goin wrong with my comp yet
  4. fritosaregood
    I think this is it, the conficker worm http://www.microsoft.com/protect/computer/.../conficker.mspx theres also a spot on the site to scan your comp for it. but we did a few computer at my house and it took 4 hours+ to do it all
  5. fritosaregood
    i know it some worm thats already in tons of computers. but it activates tonight. I think you can to do microsoft.com and find out info about it
  6. fritosaregood
    that happens to me when i click on youtube vids from the forum. but refreshin usually helps for me
  7. fritosaregood
    Its just to turn the display on
  8. fritosaregood
    + on the display to a 12 source, fuse it if you directly to the battery - on the display to the ground and turn on wire to your ignitions wire. you can splice into the ignition wire going to your h/u
  9. fritosaregood
    mine were bad until i added some polyfill
  10. fritosaregood
    nvm. i looks like they have more now
  11. fritosaregood
    200 amp alt and 2 kinetik 1800s, for this vid i only had one batt in. 2 kinetik 2400s just showed up at my door today
  12. fritosaregood
    30hz is louder but not as much hairtrick. it peaks at 41 hz in the car 15hz - 22hz were my best hairtrick frequecies Thanks im having better luck with real low tuning.
  13. fritosaregood
    Just one 15, i got another on sittin here next to me, for my second hairtrick.hah Mine does heat up some, after playing full tilt for a while, but never hot hot. But I think thats what its suppose to do, the cone is like a heatsink for it. Thats wat the Audiopulse site says about it. Ive got a temp gun somewhere. ill have to see what temp it gets up to.
  14. fritosaregood
    Thanks, I may have an even better one this summer. another axis and another sundown :hairtrick:
  15. fritosaregood
    15" Audiopulse Axis powered by a Sundown3000=My first hairtrick I finally got my good axis back on my good box and into the car. Im takin it up to a comp saturday to get it metered. While i was tuning it i notice my hair moving, so i got my gf to come over to try a hairtrick enjoy
  16. fritosaregood
    why? Is it two boards internally bridged?
  17. fritosaregood
    Mine just showed up today. I think PE is sold out of them now
  18. fritosaregood
    Seems like a not so smart amp design, you could do a run of 0 gauge to the amp fuse the 0 gauge. then use a distro block to make it into 2 4 gauge wires
  19. fritosaregood
    with all 8 subs youll end up with a final load of 1 ohm.
  20. fritosaregood
    Dumb question, but how is Fi read. Ive always called it F.I. but i saw a vid on youtube a little bit ago and they called it "phi". Which is right?
  21. fritosaregood
    good deal. you should definately be in the 50's
  22. fritosaregood
    i think he meant 100 sq inches, which is still kinda low. maybe 120sq in
  23. fritosaregood
    If you plug the 4 ohm sub in the 8 ohm speaker output, over heating problems can come up What i am saying though; If the reciever allows you to directly hook up the sub to the reciever, as in a channel for sub use only, it will usually(check the manual for specs)have a lower impedence rating like 4 ohms. then it will be ok
  24. fritosaregood
    If you can run the sub directly off the reciever there will be a speaker wire output designated for the subwoofer. and you should have no problem running it like that
  25. fritosaregood
    4 12s, 8.5 cubes. and only 60in^2 of port area Shouldnt you go bigger on the port area
×
×
  • Create New...