fox_racin4

keep an eye on the ipod cabke.. my dash has eaten 2 so far.. lol

i shall give that a try! i do need to rebuild baffle soon.. but it will still be either port accross top or some type of clamshell.. no side ports for me..

I do have a TL here, The thing that gets me,is the SA10s were fine, and they were getting quite a bit more power Where should i place the TL? I dont want to keep playing it when the "problem" is happening, as im sure its not very good for the subs lol

wiring has been more then tripple checked lol

thats what next.. apparently it helps alot and usually gains quite a bit, even tho its not built for numbers

both sides read 1.2ohm on DMM shitty camarah ftl theres no scratching

heres a shit wiring diagram basically, theres 6 subs per pair of 4500s, at 1.2 strapped theres 4 sets of .66 loads, which i seriesd to 2 1.2 ohm loads so each pair of amps has 6 subs at 1.2 strapped

exact same box, pulled SA10s out sat after show had XFLs in by sunday at 10pm heres a quick vid only really noticeable at 5 sec in and right at the end, the pinging noise IS NOT THE SUBS! lol

15cubes before sub displacement And 4 sax4500s at .6ea Subs are probly getting just over rated power

I need to doors closed to demo, 1. It 6758 times louder and 2. Subs unload quick with doors open Thing is it never did it before, and the HZ area it does it in is where i bassrace...lol

I need to doors closed to demo, 1. It 6758 times louder and 2. Subs unload quick with doors open Thing is it never did it before, and the HZ area it does it in is where i bassrace...lol

ill try to get a vid of it.. it seems to be 3 or 6 of the subs behind the drives seat, kind of hard to watch all of them hahaha anything in the mid 40hz area will do it.. gotta run out for a bit will try to gets a vid!

never did it with the SA10s tho!

Ok, have an odd problem i need some quidance with... Playing the subs ( AB XFLs ) and songs that have notes in the 46hz area ( lil jon push that, The higher note in no hands) The subs behind drivers seat will unload. They do it with and without the seat in the truck. Any other notes are fine as far as i know... Tried re-wiring the subs, switched amps (switched leads at amps) Im out of ideas

haha yep.. i need a shorter belt but cant find one.. it only slips when i load the alts down tho

No.... Its a very common problem

If i had more free time Id say get te wood , and a table saw And lay my gas thre and back and id help ya

im not to far i dont think, im a few min from detroit, in Windsor eh

If you know what your doing...yepp

Dont make me drive to OH!!! I seen JB weld, But then he said weld With no JB infront of it.. And me being a welder When i see weld i dont think of jb weld lol

i dont think welding a magnet would work to well....... IIRC heat and a magnet dont mix..

bumpp

Tried, mobile fail Haha

can get it decently cheap BNIB fully loaded just dont want a paperweight

may pick up a UFO style BTL with the single slug ( NOT the 4 smaller pie shapped slugs) and it has a carck.. IIRC they were known for cracking which is why they switched to the 4 pie shapped slugs, what glue can i use to just.. reinforce the crack?