Cozmoo

oh. Ok. Well thanks for your help guys. Ima go hook it up and ill be back in a few to let yall know if i got it ;D

what I am asking is do you use negative wire or positive wire to connect open negative and positive terminals on the subwoofer.

ooh so I just take some speaker wire and hook the positive wire to the positive coil and the negative to the negative. what about the other ends of the positive and negative? let them hang there? because if you are only using one side of the positive, and one side of the negative.

my amp said 200 Watt x1 @4ohms bridged. whatever that means. it also said Do NOT use 2 Ohm speaker load in bridged mode. that is probably why it was cutting out. I understand that picture to an extent. I understand you do the positive to the positive on coil one. and the negative to negative on coil two. but what about the right side of the picture where it goes from negative coil to positive? how do I hook that up?

Sorry I took so long, been really busy. The woofer is a 12" P312D2 Dual 2 Ohm 500 watt RMS 1000 watt max the amp is a 340 watt Dual XiA2346 2/1 Channel Amp My current setting is I am using it bridged on one coil. I bought this sub pretty new off of craigslist because my old 12 for some reason blew and won't play over 15 volume, because the amp would go into protect. My friend tuned this amp by ear because none of us have O-Scopes but I switched the Crossover from Full to LPF, so now it just plays bass instead of music. I have no idea what the Input level or Crossover Frequency is on. But the input level goes from 6V to 200mV and the Crossover Frequency goes from 40Hz to 400Hz Right now, if I have the SUB setting on my headunit set to 7-10, if I turn my volume over 18, my sub wont play when bass hits(the amp goes into protect). I don't know if it is a problem with my amp, but sometimes my car doesnt start..like it is totally dead until you touch the negative terminal on my battery, then it starts up. I think it needs cleaning, that might solve it. But yeah, those are the specs. I hope you can help on how to set it up.

Hey, I just bought a 12" Rockford P3 off of Craigslist and at the moment I only have it wired to one coil, which I know is bad and am working on hooking up the DVC. I have a 340watt dual amp that I am using bridged. should I hook up both coils while bridged, or should i use one channel per coil? The woofer on the rockford site says min 150watts maxx 500

Put Me In The Freezer - Baby D Muscle Cars - E-40 Da Blow - Lil Jon Thuggin - Webbie I Put On - Young Jeezy