Jump to content

ramon091

Members
  • Posts

    5
  • Joined

  • Last visited

About ramon091

Profile Information

  • Gender
    Male
  • Location
    STATEN ISLAND,NY

ramon091's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Doesn't look like its Mac compatible Definitely looks appealing ....
  2. The problem is your checking resistance with the power on and as far as basic electricity is concerned you do not check resistance with power on ever ., hence why you are getting an irractic reading on your meter also you run a possibility of blowing your fuse in the process but for the most part your wiring is fine if it's a one ohm load you wanted to achieve ., notice how you read fine with power off ..
  3. very true ..lol.brain fart ...i stand corrected ....thank you for the correction ..lol
  4. Remember length times width gives you the square footage ...........and when you multiply the base times the height and divide it by 2 ...that gives the area .......good luck on your project ........
  5. Measure length and width, multiply these two numbers to get the square footage , and always add maybe about 10% extra just because things never usually go the way you want lol.....so basically if your vehicle's rear trunk area is 28"in length and 49"in width convert those numbers to feet which basically gives you 4ft 1" by 2ft 4" multiply them and your trunk will need 6ft 4inches ...don't forget to add 10% more .......and basically that's it i hope this was helpful .....
×
×
  • Create New...