andnowforme

I have a 2.5 cube box that my old m1 level 3 12 is in right now. But, I think the m2 level 3 with a level 4 coil is the best bet. Thanks!!

Which level m2 12 would run best on the 1.2k at 1 ohm? I have the big 3 run and kinetic under the hood. My voltage doesn't go under 14.2 at full tilt now on 2 ohms. Thanks.

Will that be a M2 level 3 18??

I have a level 3 12 in a 3 cubic foot box before displacement on a 1.2k at 2 ohms. Hits hard as Hell but I had to turn my subsonic up to 30 to avoid those super low notes. Sub can get hot after 30 mins at full tilt though.

So a 1.2k on one m2 level 4 at 1ohm would push it?

Where is autorama held?

I had an older t1000bd and switched to a 1.2k. I did gain a bit of power but the biggest difference was how much more efficient the dc amp was. I had some voltage drop with the rf but with the dc, none at all. It seems the dc didn't need to draw as much voltage to maintain the power.

I have a kinetic 1400 under the hood with the big 3 and a 110amp alternator and when I'm pushing it I drop to 13.6 volts. I run it about 40 min to get to work and that's the lowest I see.

My friend had the same noise from his dc....turned out the woofer was fine and he had a bad channel on his amp..

I just installed this amp so if you want to check it out go to my YouTube channel YouTube.com/slaparu to see it. The power and ground are 4 gauge which I was surprised by too. It does 780 rms at 2 ohm and 1250 rms at 1 ohm. If you have any questions hit me up...

Amps r in...picking mine up tomorrow...sweet

So r the amps in? I'm local and want to pick mine up Tom...

Did u pick them up at dc hq?

So the amps r in ?