Jump to content

sierra mist

Members
 View Profile  See their activity

  • Posts

    818

  • Joined

  • Last visited

About sierra mist

  • Birthday 09/13/1980

Contact Methods

  • AIM
    ctl4698
  • Website URL
    http://
  • ICQ
    0
  • Yahoo
    mr_ctlewis

Profile Information

  • Gender
    Male
  • Location
    Benton, AR

sierra mist's Achievements

Newbie

Newbie (1/14)

  • Week One Done Rare
  • One Month Later Rare
  • One Year In Rare

Recent Badges

6

Reputation

  1. sierra mist
    sierra mist changed their profile photo
  2. sierra mist
    Steve, I need to clean up the amp rack(read MDF board) in my 04 Escalade. Is his amp rack bolted to those seat rods? I'd like to build an amp rack like this. Thank you guys for sharing. I wouldn't think doable without this post.
  3. sierra mist
    x2
  4. sierra mist
    Any reason these are discontinued. Also, what are they being replaced with? I see you guys still have the dual 2 ohm version, but it's OOS.
  5. sierra mist
    I just purchased the app. Could an addition be made for a sealed box designer? I'm sure most folks go ported, but I think having that would be awesome.
  6. sierra mist
    SLT with 4x4 to boot...very nice!
  7. sierra mist
    I hope you get an answer. This is the main reason I'm holding off on getting the 3sixty.3. The video Steve made was for a line driver. From the manual, the 3sixty.3 doesn't have a gain control.
  8. sierra mist
    Does using the 3sixty allow you to avoid using a relay to turn all of the amps on? I did a search on this topic and didn't see anything mentioned about a relay.
  9. sierra mist
    It was a green MEI mosfet amp. I think it was 75x2 RMS. That thing was built like a tank!
  10. sierra mist
    I went back and retested. My sub level goes to 15, not 6. With the level at 15, 33 out of 35 is the highest it will go before the distortion light comes on. When I back it down to 13, I can take the volume up to the max of 35. I'm not sure which one i should go with.
  11. sierra mist
    I just set my sub level to the highest it would go and used the max volume. I still got no distortion.
  12. sierra mist
    I will in a few minutes.
  13. sierra mist
    You make a good point about the sub level. Looks like there are several ways it can be done. I'm sure I will run the sub level over 0 at some point.
  14. sierra mist
    I think I got it now. Here are a couple of pics from when I did the mids/highs amp.
  15. sierra mist
    Got it folks! I have to same feeling as when I first learned to solder. I keep all of my settings on flat. The change came on the HUs xover. I set the front and sub to 200hz(that is as high as it would go). My headunit does not distort at the max volume of 35.
  16. sierra mist
    This is the pic of the HU sub xover. When I press the flat button, it goes back to 80hz.
×
×
  • Create New...