hubcap

also wanting to kno so i can set to dvr to watch the master at work

Will just 1 15 hold the wattage from the 1606 and will it be louder than the two in the box ihave them now it is almost 3.5 cubes before displacement

Honestly I would love to but money is to short and I buyin an suv in jan so I am gonna want my fifteens

To do that my dimentions would be 14h 35w 27d

I would have to shorten the box hight because there are brackets that touch the top of my current box but I might be able to make it deeper then I will measure asap

what would you do i have been into systems for a while but this is my first attempt at really trying to do something half a$* right i just didnt think i would have enough room on the same side of the box for subs and port due to width restrictions so i figured i would face the subs back and the port towards the cabin also if it helps at all i have a 60/40 rear folding seat and i keep the larger side down at all times i am open to any suggestions cause when it comes to this i am a noooooooooooooooob

can u help with design I have seen your designs on here and they are wickedThere is no manual/specs for the BC series, I would like to know what is the overall diameter of the sub and if you can go a bit wider than 35".

No backwards. subs trunk port towards cabin

The overall diam is 16 in

15" Dynamic Car Speaker, 1700 Watts Power (PMPO), 850 Watts Power (RMS), Frequency Response: 20-800 Hz, Sensitivity: 96 dB, Air Cushion Foam Surround Composite Cone, Chrome Die-Cast Aluminum Basket, 2.5" 4-Layer Black Aluminum Dual Voice Coil, Nom and 35 is max i am strut tower to tower now and i believe the measurement you are wanting is 35 cm

Bump

16.5 h 22 d 35 w sorry sould have put that in there

Can anyone help with port size or any opinions or ideas I just got the wood I am using 3/4 mdf board and 1/2'' all thread for braceing I want it tuned to like 32 or 33

i have a 99 monte carlo with 2 dual four ohm 15'' audiopipe txx-bc on a hifonics 1606 run at 1ohm but my box sucks major port to small been screwed together a few times so now i am trying to build a new box but once i start planning i get screwed up i know what i want and my max dims are 16.5x22x35 and i want the subs facing the trunk and the port centered facing the cabin any help is welcomed thank you

looks wicked how much did you give for the amp