emperorjj1 Posted October 18, 2006 Report Share Posted October 18, 2006 mainly to have more control over my amps kinda like meade's kill switch... also don't you need 1 after so many amps? depends entirely on the hu specs and the amount of amps.... manly the lower ends hus offer theri voltage across all teh terminals combined where as some higher end ones offer that voltage per each output so that itself matters a lot. how many amps are you looking at? aslo before buying a line driver see how much voltage your amps can handle. also im not sure what meade has but i used to have a kill switch on my amp with out a line driver... a kill switch is actually pretty easy just do up a relay that on the off positon it kills the circut so the amp would be "off". i intend to do this on all the amps i install that way i can control waht i hear and when i want to hear it... :^ Quote J. JMy CardomainFINISHED COBALT SS/SC DUAL ALTERNATOR PICS theres no such thing as too expensive when it comes to upgrades like that, because imo if you are gonna spend to upgrade then do it correctly rather then be a cheap ass ricer Link to comment Share on other sites More sharing options...
unknownuser200985 Posted October 18, 2006 Author Report Share Posted October 18, 2006 6 amps for my subs... my head unit puts out 5 volts... and they can take up to 8-9 volts rms Quote Link to comment Share on other sites More sharing options...
emperorjj1 Posted October 18, 2006 Report Share Posted October 18, 2006 is that 5v per output or in total? Quote J. JMy CardomainFINISHED COBALT SS/SC DUAL ALTERNATOR PICS theres no such thing as too expensive when it comes to upgrades like that, because imo if you are gonna spend to upgrade then do it correctly rather then be a cheap ass ricer Link to comment Share on other sites More sharing options...
AP Zoutes Posted October 18, 2006 Report Share Posted October 18, 2006 I would strongly recommend the matrix. Run two. use One for front out/rear out to front/rear amps then sub out to a second matrix then use the three outs to your sub amps. If your amps have line outs just use that. Go to the matrix site look up the manual they have the exact setup I'm talking about diagrammed Quote Link to comment Share on other sites More sharing options...
basshead Posted November 10, 2006 Report Share Posted November 10, 2006 the audiocontrol matrix are off tha chain i will never go with anything else Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.