Jump to content

FS-Sundown3500 and copper


Recommended Posts

My sundown is only 3 months old. 1 of the months it wasn't even used. I guess it's one of the new runs of 3500s if that helps..

IMAG2842.jpg

IMAG2841_1326580934119.jpg

675$ shipped!!!!

Rated power output

RMS power, 2 ohm linkable/dual mono

7000W x 1CH

RMS power, 1 ohm mono

3500W x 1CH

RMS power, 2 ohm mono 1750W x 1CH

RMS power, 4 ohm mono

750W x 1CH

Signal to Noise Ratio >90dB

Low pass frequency crossover 35Hz~300Hz

Subsonic filter 10Hz~60Hz

Bass boost @ 45Hz 0~6dB

Phase shift control 0~180 degree

Frequency response 10Hz~350Hz (+/- 1dB)

T.H.D @ 4 ohm <0.1%

Efficiency @ 4 ohm 86%

Fuse rating 300A (external type fuse)

Input Sensitivity 200mV to 6V (+/- 5%)

Dimensions 252(W) x 53(H) x 660(L)mm

Also selling copper bussbars. 1/4" thick.....would be good to melt down or turn into a distro block

75$ shipped for all the copper

Edited by MaliB00M

www.TheAutoSkin.com

MaliBOOM v2"2010 Bagged Malibu on 20s"<< click here<<<

Excursion on 42s Build log<<Click here<<<

Instagram-@theAutoSkinRyan @TheAutoSkin

Owner of The Auto Skin

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 746 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...