Socky Posted January 19, 2012 Report Posted January 19, 2012 So i am about to build a box in a 90 cummins single cab. The measurements are 19" tall, 63" wide, and depth 1 10", depth 2 12" was wonder what are the angles that i would have to make to mount the front baffle on. Such as the top, and bottom where the baffle would mount to. Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz
jeremyg Posted January 19, 2012 Report Posted January 19, 2012 Is this what you are looking for? Google+ Profile
Recommended Posts
Archived
This topic is now archived and is closed to further replies.