dagodpere Posted February 8, 2012 Report Share Posted February 8, 2012 (edited) I've tried to set the subsonic filter on my amp the way the manual instructs me too. Each time I have tried to do so I turn the Subsonic Filter all the way up passed the 28Hz point "Where I wanted to set my Subsonic Filter" and the CC-1 still displays a down arrow indicated that the CC-1 wants me to turn the Low Pass Crossover down to meet the 28Hz frequency. So basically when I hit the read button the top arrow lights wanting me to turn down the Low Pass Crossover instead of displaying an up arrow to indicate that I have to turn the Subsonic Filter up to meet desired frequency. Am I doing something wrong or is this just a "BUG"? Any suggestions?!? If its a BUG then I would suggest - to enter into the Infrasonic read mode you would have to have the probe pluged in and you hold down the read button until the Calibration lights iluminate indicating you have enter the Infrasonic mode - and then proceed to set the Subsonic Filter. Edited February 8, 2012 by dagodpere Quote Link to comment Share on other sites More sharing options...
808BommerN702 Posted July 15, 2012 Report Share Posted July 15, 2012 i'm getting the same f!$#^ problem!!!!!! did you figure it out???? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.