all4spl Posted August 7, 2012 Report Share Posted August 7, 2012 Ok so I am again no expert, however an old friend of mine Will Alfonso suggested a BP design and below is what I came up with. Specs provided where 5.7cuft 1:1 50sqin of port area 8" long. After the suggested BP design I "tried" to mock one up in sketch up. I prolly got this all wrong but here is a picture of it with some area's left out to view the measurements. I shortened the port based on 1 shared wall, the way I got the length of the port of 5.25" is that I calculated the box like a standard ported box with torres calc at 50sqin 8" long, got the resulted tuning, then changed it to 1 shared wall, accounting for the difference of 4.5Hz I then adjusted the port lower in length till the same (within .01) tuning was obtained. I hope that made sense. Anyway here is the diagram/photo any input would be helpful as this is my first attempt at doing a BP design and I just kinda winged it based on the data given to me of 1:1 with 50sqin of port area 8" long. The box is 1:1 2.9cuft sealed, 2.9cuft ported 50sqin of port area shortened the port length as detailed above. Input? No flames por favor. Quote Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.