Jump to content
Second Skin Audio

Fi Bls Pulling In Instead Of Pushing Out


TarponPride09

Recommended Posts

maybe a video would help the diagnosis?

~Matthew

1998 Toyota Camry XLE V6 3L

(1) ScyTek Astra 4000RS-2W-1 2-Way Remote Start Alarm

with Shock and Proximity

(1) 20% Tint All Around (Gately Audio)

(1) 250 Amperage HO Alternator

(1) Big 3 Done In 1/0

(2) Kinetik HC2400 Power Cell

(1) Alpine IVA-D106 Receiver

(1) Peripheral Video Bypass Device

(4) Alpine SPS-17C2 Speakers

(1) Alpine KCE-422i iPod Control Interface

(4) Sheets Dynamat Extreme; for speakers

(1) 10 Square Feet Hushmat (Trunk & Rear Deck)

(4) DC Audio Level 4 15" D2 Subwoofer w/ Level 5 Coils

(1) Wall Built By David, Tuned to 32 Hz

(1) Rockford Fosgate T40001bd Amplifier

(1) Stinger 1/0 Wiring (2 runs of + 2 runs of -)

(1) Stinger Volt Meter

Link to comment
Share on other sites

im seriously angry because I spend like 1300 bucks on an amp and subs and now I can't enjoy them for the reason I got them

edit- the subs seemed to play just fine when I thought that they were pulling down. but the new problem is findng out and fixing the gargling noise coming from the insides of both subs

Link to comment
Share on other sites

I took them out and the bronze colored coil seems alright. I don't have a good dmm so ill borrow one tomorrow and check it out.

when I turned the amp on with the radio off they hummed and buzzed until I turned down the bass knob then it starts up again with the knob turned down

Link to comment
Share on other sites

the positive and ground are connected to the positive and negative terminals of the kinetik and then there are 2 runs of 1/0 that that are connected from the positive and negative terminals of the kinetik and starting battery could that be it. because the starting battery isn't body gounded?

Link to comment
Share on other sites

ok i got a dmm and it read 1.2 ohms for the two subs. today im going to get a body ground for the starting battery. somebody asked for a video to show excursion, but the problem is im not getting any. im actually getting de-excursion, the subs never break parallel with their starting position. also, somebody was talking about reverse polarities. could the poles of the magnet switched from north to south or something like that. thats all i can think of.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 727 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...