aculous Posted March 1, 2015 Report Share Posted March 1, 2015 So I am a total novice to bagging or dropping a car or truck. Lifting a truck done, fine no problems but never messed with doing a body or suspension drop. I not scared of fabrication work but to be honest in a truck I didn't give a shit about hacking the frame and putting in some steel tube...with a unibody I am more cautious. I was wondering how to go about it and what is the typical cost. Since its a car I don't have a ton of room for compressors and everything but I think I would have enough room to run one and maybe a ridetech suspension setup. I want to be able to take the car to the dragstrip though so I don't want something that will hinder that or make it unsafe at higher speeds. Feel free to tell me not to do it based on the above I am just wondering what I would need and would it be decent for the application. Another caveat...its my daily driver. Also do you guys recommend some reading to figure this shit out? Like I said total novice to this subject. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.