camino_1to3 Posted May 7, 2008 Report Share Posted May 7, 2008 If i've already got 0/1 gauge power and grounds thru my car, and i installed a 1600 watt amp, resist wouldn't be too high for the amp or anything would it? Or would it be necessary to downgrade to the some 4 gauge? Team T3 Audio Team Sundown Audio Team O.B.M Operation Beast Mode "Believe half of what you see and none of what you hear" wigglez that was a bit over the top, i dont want to invison dw giving any young lady a "cream pie" let alone "throat babies". Link to comment Share on other sites More sharing options...
LoudBlazer Posted May 7, 2008 Report Share Posted May 7, 2008 You want to downgrade from 0ga to 4ga? Is that what your asking? If you already have 0ga no need to downgrade to 4ga. You would prolyl have more resistance with 4ga depends on whether its copper or aluminum and the amount and ga of wire 1997 2 Door Blazer Bagged & Body Dropped SBC/TH350 Link to comment Share on other sites More sharing options...
Aaron813 Posted May 7, 2008 Report Share Posted May 7, 2008 Nope the bigger the wire the better Link to comment Share on other sites More sharing options...
camino_1to3 Posted May 7, 2008 Author Report Share Posted May 7, 2008 I knew that, i just wanted to make sure that i wasn't going to be pushing my amp too hard with so little resist.. Team T3 Audio Team Sundown Audio Team O.B.M Operation Beast Mode "Believe half of what you see and none of what you hear" wigglez that was a bit over the top, i dont want to invison dw giving any young lady a "cream pie" let alone "throat babies". Link to comment Share on other sites More sharing options...
LoudBlazer Posted May 7, 2008 Report Share Posted May 7, 2008 The less resistance in your wire the better! Wont hurt the amp at all with lower resistance in your wire! 1997 2 Door Blazer Bagged & Body Dropped SBC/TH350 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.